Josh
09-16-2014, 12:03 PM
Just putting this up to see if there is any interest. Thinking about swapping in a different engine and upgrading to MS3.
As pictured:
30829
3.0 eagle premeir prv running MS2 with EDIS ignition
Everything for sale would include:
3.0 eagle premeir engine
All accessories (alt,a/c, waterpump)
Intake, throttlebody, injectors, coils,etc
Clutch, pressure plate, flywheel
DMCH early stage 1 exhaust (mild steel)
All sensors (including custom fabricated crank position sensor)
Fuel lines (fasten directly into stock delorean feed and return lines)
All sensor wire pigtails
EDIS module
MS2 3.57 and Innovative LC2 wideband modules
It may be easier indicating what would not be included, lol.
-Intake piping
-Engine wiring (however, all sensors and pigtails will be included and labelled as well as a detailed wiring schematic i drew up during installation)
I would also provide my current tune to get you up and running. This setup could be swapped over in a weekend basically.
The engine had about 60,000 mi when I swapped it in and I have put on 10,000 this year. Most everything is new as of this year(accessories, clutch, etc). It runs great. Comparable power to a stage 2. I can get near 30mpg on regular 87 octane on the highway.
The only work it needs is to clean a few hydraulic lifters or replace. There is a very slight tick at idle.
I would be asking 3000 obo + shipping for the complete setup. I would be willing to travel a bit (across border) to save on shipping. If you are interested feel free to comment or send a PM
As pictured:
30829
3.0 eagle premeir prv running MS2 with EDIS ignition
Everything for sale would include:
3.0 eagle premeir engine
All accessories (alt,a/c, waterpump)
Intake, throttlebody, injectors, coils,etc
Clutch, pressure plate, flywheel
DMCH early stage 1 exhaust (mild steel)
All sensors (including custom fabricated crank position sensor)
Fuel lines (fasten directly into stock delorean feed and return lines)
All sensor wire pigtails
EDIS module
MS2 3.57 and Innovative LC2 wideband modules
It may be easier indicating what would not be included, lol.
-Intake piping
-Engine wiring (however, all sensors and pigtails will be included and labelled as well as a detailed wiring schematic i drew up during installation)
I would also provide my current tune to get you up and running. This setup could be swapped over in a weekend basically.
The engine had about 60,000 mi when I swapped it in and I have put on 10,000 this year. Most everything is new as of this year(accessories, clutch, etc). It runs great. Comparable power to a stage 2. I can get near 30mpg on regular 87 octane on the highway.
The only work it needs is to clean a few hydraulic lifters or replace. There is a very slight tick at idle.
I would be asking 3000 obo + shipping for the complete setup. I would be willing to travel a bit (across border) to save on shipping. If you are interested feel free to comment or send a PM