View Full Version : Fitting a toothed timing wheel to a stock engine?
Mark Hershey
10-26-2015, 07:10 AM
Any of you EFI guys use a timing wheel (36-1 or otherwise) on a stock PRV engine, using either the stock crankshaft pully or something custom ( machined custom pulley, for example)?
Looking for a source for a pully+wheel, or thoughts on fitting an off-shelf wheel to the existing pulley. Thanks!
//
dn010
10-26-2015, 08:39 AM
I'm using a 36-1 wheel bolted to the back of a B280F pulley with the last groove (closest to the timing cover) cut off. It may be possible to weld one onto a stock pulley, but I opted to only bolt it on so that I'd have adjustability. The wheel I got was from DIY Auto Tune. I'm sure you can also cut teeth into the last groove of the stock pulley without having any adverse effects on the belt.
on a 3.0 but would work the same with 2.8 v belt setup.
http://i84.photobucket.com/albums/k38/jschatte/Facebook/Project%2082%20Delorean/10308175_833408566672658_4604407445116557359_n.jpg (http://s84.photobucket.com/user/jschatte/media/Facebook/Project%2082%20Delorean/10308175_833408566672658_4604407445116557359_n.jpg .html)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.