content22207_2
07-27-2016, 04:14 PM
Finally getting around to putting a carb on my Volvo. Coolant distribution pipe doesn't appear to have ever been removed (all hoses under the intake were marked "Volvo"). Despite using a 3/8 impact gun, one of the bolts snapped off:
44887
5/16" nut fits a 7mm bolt shank perfectly:
44888
Welding blanket for protection (I use flux wire, which throws a lot of sparks. On the plus side it doesn't care about coolant all over the place, or being outside):
44889
Nut welded on:
44890
Broken bolt removed. I just turned it out with a flat wrench. Obviously heat from the welding broke it free:
44893
Bill Robertson
#5939
44887
5/16" nut fits a 7mm bolt shank perfectly:
44888
Welding blanket for protection (I use flux wire, which throws a lot of sparks. On the plus side it doesn't care about coolant all over the place, or being outside):
44889
Nut welded on:
44890
Broken bolt removed. I just turned it out with a flat wrench. Obviously heat from the welding broke it free:
44893
Bill Robertson
#5939