View Full Version : General Bracket To Refit Original Craig Radio
Hi all,
I've bought a Craig radio to refit in the car, the previous owner has widened the the gap to fit a modern radio (as shown in the photo).
I'm sure someone has solved a similar problem, any suggestions without replacing the entire mounting plate?
Cheers,
Max
https://i.imgur.com/JHUvmvkh.jpg
David T
07-01-2018, 12:50 PM
One way would be to make a metal plate to replicate the original holes and attach it to the bracket but you would need to make a plastic trim piece to cover it all up. Another possible solution is if you can get a DIN adapter with parts to fit the Craig into it.
arrow_runner
07-02-2018, 09:19 AM
I bet you could get a vinyl wrap that would look close to that paint/texture. What David said about making one bending/cutting metal is the way I would go unless one came up for cheap.
FABombjoy
07-02-2018, 02:05 PM
Something like this perhaps?
https://www.amazon.com/American-International-UI-K1400-Conversion-Installation/dp/B000VAXGEQ
It may stick out a little bit more than stock but it saves you from having to pull the console
Chris 16409
07-02-2018, 06:48 PM
Why don't you post a trade thread on the for sale section. I'm sure there is someone who would like to have DIN sized bracket and you can trade for the shaft style bracket.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.