PDA

View Full Version : Electrical Connector question


lorentbj
06-12-2011, 09:48 PM
New guy to forum-I was having a little fun changing Dist. cap and while moving wiring harness to get cap in place a connector popped off.Its a black water tight connector with wire snap maybe for an injector or a sending unit.Can not figure out what it snaps on to.Any help?
thanks
dmc6960
06-13-2011, 10:32 AM
Does it have 3 wires? If so its for the idle motor/regulator.
lorentbj
06-13-2011, 07:23 PM
Does it have 3 wires? If so its for the idle motor/regulator. no it is 2 wire.I will have to get a picture and post it.
82DMC12
06-13-2011, 08:46 PM
I bet it's the electrical connection for the ignition vacuum advance solenoid. It's located behind the fuel distributor.

Andy
dmc6960
06-14-2011, 10:59 AM
Need picture. The vacuum solenoid would be a possibility, but that connector doesn't have a "wire snap" on it. The other 2-wire "snap" connectors are for the cold start valve (blue), CPR (grey), and the frequency valve (I thought was white).

It is also possible any one of those were replaced with a generic black unit at some point in the past.