DeLorean03
12-08-2012, 10:49 PM
Hey everyone,
So I am installing Toby's Door Launchers, and it's the weekend so I figured I'd ask here until I can get to Toby on Monday. So far, everything is going fine; I am currently wiring everything up to the controller/DMCH door module/relays, and I had a question. Obviously, this will be geared towards those who have installed the kit.
So, third bullet under "Remote Controller Central Processor", it says "The black wire should be connected to a good quality ground...."
My question - there are two black wires: 1. Going from the back of the main controller black box... 2. The other is coming off of a wiring loom that consists of two wires (a red power wire with an inline 2A fuse and then a black ground wire). Which black wire are the instructions referring to - the one by itself on the main black box controller or the black wire that is part of the two wire loom ?
And even then, once one of these two black ground wires is used, where does the other one go... ?
Thank you!
So I am installing Toby's Door Launchers, and it's the weekend so I figured I'd ask here until I can get to Toby on Monday. So far, everything is going fine; I am currently wiring everything up to the controller/DMCH door module/relays, and I had a question. Obviously, this will be geared towards those who have installed the kit.
So, third bullet under "Remote Controller Central Processor", it says "The black wire should be connected to a good quality ground...."
My question - there are two black wires: 1. Going from the back of the main controller black box... 2. The other is coming off of a wiring loom that consists of two wires (a red power wire with an inline 2A fuse and then a black ground wire). Which black wire are the instructions referring to - the one by itself on the main black box controller or the black wire that is part of the two wire loom ?
And even then, once one of these two black ground wires is used, where does the other one go... ?
Thank you!