View Profile: David T - DMCTalk Forum

Tab Content: All; David T; Friends; Photos

Older Activity
04-13-2024, 01:40 PM

David T replied to a thread [General] Happiest Day for a New Owner in General DeLorean Discussion

This last video was great showing how difficult it can be doing exhaust work. An acetylene torch is indispensable. If you must have this kind of work...

see more

51 replies | 6568 view(s)
04-12-2024, 03:46 PM

David T replied to a thread [Engine] Silicone oil pan gasket in General DeLorean Discussion

I never saw a silicone gasket used there. The original OEM one was some kind of composite materiel that becomes hard as a rock. A real PITA to clean...

see more

11 replies | 593 view(s)
04-11-2024, 08:53 AM

David T replied to a thread [Fuel] New Owner first Question about injectors in General DeLorean Discussion

Not only will you have to work on the fuel system, the brake and clutch systems are probably in need of a lot of work. Cooling system too. Get in...

see more

9 replies | 402 view(s)
04-03-2024, 01:43 PM

David T replied to a thread [Engine] Oil on spark plug threads in General DeLorean Discussion

Nothing is supposed to get into the spark plug wells, there is a big rubber seal that is supposed to prevent water (and oil) from getting in there....

see more

8 replies | 781 view(s)
03-31-2024, 10:06 PM

David T replied to a thread [Electrical] 12V to one cooling fan. in General DeLorean Discussion

The OEM fans draw a LOT of current,especially when they both start. You can actually feel it in the gas pedal. One reason some owners have replaced...

see more

21 replies | 996 view(s)
03-30-2024, 10:21 AM

David T replied to a thread [Frame & Body] Passenger door stuck shut. in General DeLorean Discussion

Before doing all of the adjustments you should have a good rubber seal, adjust the torsion bar, and the door lock anchor pins. It also helps if you...

see more

4 replies | 359 view(s)
03-23-2024, 10:31 AM

David T replied to a thread [Electrical] 12V to one cooling fan. in General DeLorean Discussion

If you don't see +12 volts at the plug to one fan you need to check at the relay block where the Fan Fail Bypass is to make sure you are feeding...

see more

21 replies | 996 view(s)

No More Results

David T
Senior Member

Mini Statistics

Recent Visitors

Basic Information

About David T

Signature

Statistics

Total Posts

General Information

David T Senior Member

Mini Statistics

Recent Visitors

Basic Information

About David T

Signature

Statistics

Total Posts

General Information

David T
Senior Member