Ron
Administrator

You are reading it right. (Easy to see- If you unplug the double PK wires from your blue diode, the 3 passenger lights will work and the interior...

:welcome:

I'm thinking you are both correct- The WSM schematic shows two left door switches. Both numbered 41. Both have Purple/Blue wires, which do not tie...

+1 for Delco (best bang for bucks, imho). Good link about batteries HERE.

No, a clogged WUR/CPR screen will cause the control pressure to be too strong: The primary pressure from within the FD is applied to the plunger,...

Not for a DeLorean, but you can get the idea: They are only needed if the pulley's mating surface for the seal has been damaged causing an oil...

I was going to say make one, if the old line going from the FD to the CPR/WRU was ok...I thought you said you were retired...:deviltail:

Yeah ~1.0Ω Most of the gauges I've seen read 1/4 @ idle then almost max out quickly. Time for the fuel pressure gauge, imho.

Got ya. ...but time has nothing to do with it, assuming it could handel 88 MPH. :)

Curious as to why you think this??

I think you meant compressor. ====== Changing over means a full flush, different oil, and a new accumulator (some say hoses too). I doubt...

Expect higher pressures and lower performance with 134a. Maybe this link?:...

This guy . It's in the center bore (see arrow): (Your's may not have the retainer.)

Correct. Could be the Fuel Distributor's (FD/mixture unit) plunger is stuck (...as said about the cat glowing earlier). The other end of each...

+1...with Mark's reply a close 2nd :):)

Probably not a good idea since it does say, "Do not attempt to close the door by exerting pressure at the front edge as this could result in a...

http://dmctalk.org/showthread.php?2755-DeLorean-Owner-s-Handbook-Manual

When I first read the thread, there were three replies (by two different members) not meeting the rules. As I said before, I would of ignored them...

Mike changed the rules because the section was being plagued with attacks against other members and/or their items, the resulting banter from other...

You must of missed the part in bold saying, "Wanted- Do not post a question or remark if you do not intend to sell an item.", again. (If a reply...

Missing a post? Please review the Stick at: http://dmctalk.org/showthread.php?18125-***-SECTION-RULES-***-Please-READ-BEFORE-POSTING-***

Seems I remember him lurking around then. :devil: ...After the BS FB has been pulling lately, I would boycott them, if I wasn't permabanned...

That end of the cable may have broken off...its part number 106804 (or #36 in the first link Rich posted above).

:cheers1:

I'm guessing you had the mode switch set to AC...