Actually mechanical speedo's are traditionally calibrated at 60MPH in the US because the highway speed limit is where the accuracy is most critical. ...
If someone changed the speedo face to a 140 or 170 MPH chances are they didn't calibrate it properly. A slipping adaptor cup would probably give very...
It's not just one vendor but all that sell the new style angle drives. These are generic 1/1 ratio units that will give a reading that is off by 12%...
I haven't seen any sign of that yet. Some prices could rise due to beneficial reasons however. As the car's value rises recreating some of the larger...
Regardless of it's affect on current owners and especially new buyers the obviously increased demand, and therefore values, can only be a good thing...
That is what I'm talking about although if the engine is set up properly it will generally rev to 2500 RPM. An incorrect CO adjusment etc could alter...
Plastigauge is used on the rod and main bearings to determine tolerances. You lay a piece across the bearing and install the cap and torque to spec....
Well if that's true that would be dated information? I'll just call David and twist his ear a bit. We get along rather well and I would love to tell...