View Profile: dn010 - DMCTalk Forum

Yesterday, 03:55 PM

dn010 replied to a thread [Frame & Body] Double Bars Blues in General DeLorean Discussion

It is hard to tell in your photos but your roof does not seem to be separating and it would be obvious. Post a photo of the back roof above the...

9 replies | 191 view(s)

Yesterday, 03:02 PM

dn010 replied to a thread [Electrical] Empty relay socket in General DeLorean Discussion

Hot start relay socket, should be empty.

3 replies | 87 view(s)

Yesterday, 02:05 PM

dn010 replied to a thread [For Sale] New Delo Tee on Blipshift.com in Miscellaneous

I went to look for it and thought I might correct the web address as blipshift.com.

3 replies | 139 view(s)

10-18-2018, 03:41 PM

dn010 replied to a thread Vendor in Product Reviews

Ball joints!

20 replies | 1231 view(s)

10-18-2018, 03:22 PM

dn010 replied to a thread [General] Preparing to sell my Delorean, but had questions on the Title (or lack there of) in General DeLorean Discussion

According to your state's DMV site, among the different types of titles they'll issue, three of them are "Warranty" (which is likely the one you'd...

14 replies | 303 view(s)

10-18-2018, 09:45 AM

dn010 replied to a thread Vendor in Product Reviews

I'll keep it short: Some of the parts I got from DAP/SpecialT could have killed me and almost wrecked my car. I was lucky it wasn't worse than it was.

20 replies | 1231 view(s)

10-17-2018, 02:31 PM

dn010 replied to a thread Delorean That Got Away in Open Discussion

That is a car that's stood for quite a time and has not been touched at all. Compared to my current car, 5003: the previous owner left the car in a...

15 replies | 447 view(s)

10-17-2018, 12:17 PM

dn010 replied to a thread Delorean That Got Away in Open Discussion

For $1500, sure. For more $? - IMHO it may have been a good thing you didn't become owner of it. From the looks of it, I'd suspect it has sat where...

15 replies | 447 view(s)

10-17-2018, 09:24 AM

dn010 replied to a thread [Suspension] Short lower speedometer cable rubbing against tire in General DeLorean Discussion

I have the version with the plastic clip and I still needed to tie-wrap the cable out of the way. It seems the only thing the clip does is support...

9 replies | 219 view(s)

10-16-2018, 09:18 AM

dn010 replied to a thread [General] New Lawsuit: DeLorean Estate v. DMCH in General DeLorean Discussion

https://www.foxnews.com/auto/court-tosses-delorean-lawsuit-over-back-to-the-future-royalties

16 replies | 1304 view(s)

10-09-2018, 03:11 PM

dn010 replied to a thread Inner Door Seal in Open Discussion

I replaced my seals maybe a year or two ago and they're already ripped as well. Not only that, my doors do not open or close easy with them compared...

28 replies | 1262 view(s)

10-08-2018, 05:48 PM

dn010 replied to a thread Door Edge Guard from Amazon in Product Reviews

Sorry for the long few hours. Photos are below. The trim is flat on the outside, the curved side facing in. The corners could stand to be trimmed a...

5 replies | 295 view(s)

10-08-2018, 10:05 AM

dn010 replied to a thread [Wanted] Door mirror motor in DeLorean Parts

I recently opened my mirror motor in order to determine why my mirror would only tilt up/down but not side to side. You didn't drill out all those...

1 replies | 117 view(s)

10-05-2018, 08:59 AM

dn010 replied to a thread Door Edge Guard from Amazon in Product Reviews

I think it is a little bit thicker because it is more of a D shape and I believe the original was more of a U shape. I will take some photos and post...

5 replies | 295 view(s)

10-04-2018, 04:24 PM

dn010 started a thread Door Edge Guard from Amazon in Product Reviews

"Besteek Door Edge Guard/Protected Lining/Trim Molding" from Amazon. $9 for 32 feet of this stuff is perfect for all your stainless edges. There...

5 replies | 295 view(s)

10-03-2018, 04:34 PM

dn010 replied to a thread [Frame & Body] Leaking Divide Channel in General DeLorean Discussion

I think I am all done finally. I cut out the passenger divider, cleaned it up which made almost all of the existing rubber / urethane come off so I...

12 replies | 472 view(s)

10-03-2018, 03:11 PM

dn010 replied to a thread [Electrical] Mismatch between electrical diagram, fuse identifiers and my car in General DeLorean Discussion

I've found the wiring to be different between very early vins compared to others. I am sure your front wiring harness that goes to the fuel pump and...

5 replies | 251 view(s)

10-02-2018, 08:09 PM

dn010 replied to a thread [Engine] Emissions fail - high hydrocarbons in exhaust in General DeLorean Discussion

+1

104 replies | 3909 view(s)

10-01-2018, 02:21 PM

dn010 replied to a thread [For Sale] Parts For Sale - 16506 - Spring Cleaning in DeLorean Parts

Is the broken defrost switch available as well?

23 replies | 4847 view(s)

10-01-2018, 12:45 PM

dn010 replied to a thread [Frame & Body] Leaking Divide Channel in General DeLorean Discussion

Unfortunately I am back to the beginning on the passenger side. The tape securing the divider let go and allowed it to move downward away from the...

12 replies | 472 view(s)

09-30-2018, 05:03 PM

dn010 replied to a thread [Frame & Body] Leaking Divide Channel in General DeLorean Discussion

Windows tinted to 5%. Read about how it's likely too dark for night driving but I hardly drive at night so I went with it anyway. I figured my...

12 replies | 472 view(s)

09-28-2018, 11:08 AM

dn010 replied to a thread [Electrical] Bulkhead pins pushed in - Reverse light in General DeLorean Discussion

See post #19 here: http://dmctalk.org/showthread.php?40-All-Wiring-Schematics/page2 The wire going to the dash light from the alternator is not...

10 replies | 276 view(s)

09-26-2018, 07:32 PM

dn010 replied to a thread [Engine] A hole in the intake manifold in General DeLorean Discussion

Looks like a hole to me. A paperclip would have helped determine prior to the JB weld...

4 replies | 340 view(s)

09-26-2018, 07:26 PM

dn010 replied to a thread [Frame & Body] Leaking Divide Channel in General DeLorean Discussion

I've decided to forego the primer, for windshields that are part of the structure I'd definitely go for it but for this I think I'll try getting by...

12 replies | 472 view(s)

09-26-2018, 07:07 PM

dn010 replied to a thread [Electrical] Bulkhead pins pushed in - Reverse light in General DeLorean Discussion

The bulkhead connectors caused me very much agony with numerous engine and tail light problems. Even still with the driver side mirror I am having...

10 replies | 276 view(s)

09-26-2018, 04:39 PM

dn010 replied to a thread [Electrical] Bulkhead pins pushed in - Reverse light in General DeLorean Discussion

You remove the three or so bolts holding the carpeted rear bulkhead assembly behind the cargo net and then either flip the "assembly" down or remove...

10 replies | 276 view(s)

09-26-2018, 03:35 PM

dn010 replied to a thread [Frame & Body] Have you used a Plastic Restorer on the Louvre and Trim??? in General DeLorean Discussion

Black Magic Tire Wet all the way!

6 replies | 244 view(s)

09-26-2018, 02:35 PM

dn010 replied to a thread [General] What is smartest headliner replacement? in General DeLorean Discussion

You can also lay a few sheets of fiberglass / epoxy down on the original boards if you're worried about how rigid they are and might help with...

14 replies | 860 view(s)