View Profile: Mark413 - DMCTalk Forum

Yesterday, 03:57 PM

Bitsyncmaster replied to a thread [Electrical] Ground points in General DeLorean Discussion

When you shut the door it vibrates the bad connection. My bet is the feed through bolts at the back of the relay compartment are not tight.

6 replies | 150 view(s)

04-20-2021, 08:15 PM

Bitsyncmaster replied to a thread [Engine] Car running poorly in General DeLorean Discussion

When you unplug the WUR connector it takes a long time for it to go into normal mode. When cold your mixture is very rich. So it looks like your...

30 replies | 424 view(s)

04-20-2021, 08:07 PM

Bitsyncmaster replied to a thread [General] Suddenly won't start?? Need suggestions in General DeLorean Discussion

Some cars with the OE RPM relay will prime when the key is turned on. Some won't. The OE RPM relay can pick up an ignition pulse when the key is...

15 replies | 458 view(s)

04-18-2021, 05:56 PM

Bitsyncmaster replied to a thread How to- exhaust manifold in How-To Guides

I also have a MIG. It's nice to weld with one hand and very fast for a long weld. Making spot welds to hold things in place is also useful. I do...

6 replies | 193 view(s)

04-18-2021, 05:51 PM

Bitsyncmaster replied to a thread [Fuel] Delphi Fuel Pump DFG0089 & Hardware replacement in General DeLorean Discussion

You would need the mating electrical connector. The quick connect fittings for the fuel pump (outlet and return). Some extra hose if yours is to...

56 replies | 1464 view(s)

04-18-2021, 01:59 PM

Bitsyncmaster replied to a thread [Transmission 5-Speed] Manual transmission end cap seal in General DeLorean Discussion

The paper gaskets require perfect mating surfaces. If it's not a critical dimension, I cut thicker gaskets. For the W pipe I did that and used a...

5 replies | 205 view(s)

04-17-2021, 02:41 PM

Bitsyncmaster replied to a thread [Fuel] Delphi Fuel Pump DFG0089 & Hardware replacement in General DeLorean Discussion

Because our tank has a very small rib on the pump hole, The V clamp does not pull the pump down tight. It just holds it where you push is down. I...

56 replies | 1464 view(s)

04-16-2021, 05:17 PM

Bitsyncmaster replied to a thread [General] Suddenly won't start?? Need suggestions in General DeLorean Discussion

Yes you need a mechanic that knows our car. The fuel pump only runs when the engine is firing. It's a simple test for those in the know to jumper...

15 replies | 458 view(s)

04-16-2021, 05:14 PM

Bitsyncmaster replied to a thread How to- exhaust manifold in How-To Guides

We think alike. I just thought of that when I was in the garage and saw my TIG welder. My TIG can do stick welding and adjustable amps. Just...

6 replies | 193 view(s)

04-16-2021, 01:32 PM

Bitsyncmaster replied to a thread How to- exhaust manifold in How-To Guides

I like that idea to use a battery to heat a stud. Never heard of that before. I would guess most of heat would be right at the threads in the block....

6 replies | 193 view(s)

04-16-2021, 08:13 AM

Bitsyncmaster replied to a thread [General] Best battery cut off switch? in General DeLorean Discussion

I've seen some solid state battery relays from $150 to $500. I'm concerned about the inductive spikes from the starter causing a failure of these. ...

48 replies | 8240 view(s)

04-15-2021, 02:39 PM

Bitsyncmaster replied to a thread [General] Suddenly won't start?? Need suggestions in General DeLorean Discussion

Most common issue is the pins on the resistor in the engine bay. Pull those connections off and back on. But there are a lot of other things it...

15 replies | 458 view(s)

04-15-2021, 06:23 AM

Bitsyncmaster replied to a thread [Electrical] Pulling Relays in General DeLorean Discussion

Here is my thread on what I did. I think Toby is selling something similar now. http://dmctalk.org/showthread.php?10918-Latching-Battery-Relay

8 replies | 343 view(s)

04-14-2021, 03:59 PM

Bitsyncmaster replied to a thread [Fuel] Delphi Fuel Pump DFG0089 & Hardware replacement in General DeLorean Discussion

My pump is the Bosch 67317. I got that one because the owner that convinced me to design the fuel gauge ECU also used that one. I don't know if...

56 replies | 1464 view(s)

04-14-2021, 12:12 PM

DMC-81 replied to a thread Club T-shirts and limited edition 40th anniversary patches now available!! in The DeLorean Club of Florida (DCF)

Thanks for the tip Luke. That's unfortunate. Also thanks for the shirt compliment. :) We plan to replenish soon.

5 replies | 287 view(s)

04-14-2021, 11:20 AM

Bitsyncmaster replied to a thread [Electrical] Pulling Relays in General DeLorean Discussion

I must admit I've pulled relays without disconnecting the battery but my relay pulling tool is safe for that but now that I have a battery disconnect...

8 replies | 343 view(s)

04-14-2021, 05:48 AM

Bitsyncmaster replied to a thread [Fuel] Delphi Fuel Pump DFG0089 & Hardware replacement in General DeLorean Discussion

My pump is pretty loud. Not sure if it's the pump I installed or something with my setup. My pump has a metal top but I think it may be I need to...

56 replies | 1464 view(s)

04-13-2021, 05:17 PM

Bitsyncmaster started a thread [Electrical] Pulling Relays in General DeLorean Discussion

When pulling your relays with a metal tool, make sure you disconnect the battery first. Many relays have battery connections always powered and...

8 replies | 343 view(s)

04-13-2021, 03:13 PM

DMC-81 replied to a thread Club T-shirts and limited edition 40th anniversary patches now available!! in The DeLorean Club of Florida (DCF)

Hi There, I think that should be possible. If you can provide your address in a Private Message, I'll have our store administrator confirm and get...

5 replies | 287 view(s)

04-13-2021, 12:24 PM

DMC-81 replied to a thread [Fuel] Replacing the Frequency Valve and Return hoses in General DeLorean Discussion

Hi Mark, It worked for me. There was adequate clearance, at least for my completely stock set up.

21 replies | 3455 view(s)

04-13-2021, 07:13 AM

Bitsyncmaster replied to a thread [Fuel] Delphi Fuel Pump DFG0089 & Hardware replacement in General DeLorean Discussion

I think they all have that tab. It's a good idea to have a way to not have to cut it off. Not only for guarantee but if you have to replace it on...

56 replies | 1464 view(s)

04-11-2021, 07:09 PM

DMC-81 started a thread Club T-shirts and limited edition 40th anniversary patches now available!! in The DeLorean Club of Florida (DCF)

Hello there, Our new club T-shirts and a limited edition 40th anniversary patch are now available on our new website store. Here is...

5 replies | 287 view(s)

04-11-2021, 06:46 PM

Bitsyncmaster replied to a thread [Fuel] Delphi Fuel Pump DFG0089 & Hardware replacement in General DeLorean Discussion

In post 21 of my thread, I posted a number for the clamp but have not tested it. ...

56 replies | 1464 view(s)

04-09-2021, 12:34 PM

DMC-81 replied to a thread RIP - Howard Weitzman - former attorney for JZD - dies at 81 in Open Discussion

Yes, RIP - Mr. Weitzman There was a lot of coverage for DeLorean's trial in that article.

1 replies | 157 view(s)

04-03-2021, 06:27 PM

Bitsyncmaster replied to a thread [General] Delorean GreenBox in Custom DeLoreans/Mods

Well I finally got a chance to play with the green box. I'm just bench testing in my workshop. Hooked up the GPS antenna and did not expect it to...

5 replies | 874 view(s)

04-02-2021, 10:17 PM

cpistocco replied to a thread The Official "DeLoreans in music videos" thread in Videos

Also- not a video- but a song. “Rock Soldiers” mentions Delorean.

132 replies | 56136 view(s)

04-02-2021, 03:15 PM

Bitsyncmaster replied to a thread [Engine] car runs for 2-3 minutes then dies. in General DeLorean Discussion

Jumping the RPM relay connector pins 30 and 87 should only run the fuel pump. Jumping 30 and 87b should only run the lambda. You can make a jumper...

32 replies | 924 view(s)

04-02-2021, 12:27 PM

Bitsyncmaster replied to a thread [Electrical] Wiring at the fuel tank / extra grounding wire? in General DeLorean Discussion

Most accidents the engine would probably shut off since your stopped in gear (for the 5 speed). So it would be rare that the engine keeps running.

11 replies | 307 view(s)

Mark413
Junior Member

Mini Statistics

More 13 Friends

gongloo

clenet

MSpieler

PJ Grady Inc.

cpistocco

lazabby

2 Groups

1981 Automatic Club

DMA

Join Groups 0 Permission Groups

Recent Visitors

Basic Information

About Mark413

Statistics

Total Posts

General Information

13 Friends

acaciolo

Bitsyncmaster

clenet

cpistocco

DannonWeb

DMC-81

gongloo

lazabby

Mcv200

MSpieler

Mark413 Junior Member

Mini Statistics

More 13 Friends

2 Groups

Join Groups 0 Permission Groups

Recent Visitors

Basic Information

About Mark413

Statistics

Total Posts

General Information

13 Friends

Mark413
Junior Member