I'm working on printing an HVAC faceplate with improved less light bleeding shields. My Formlabs printer can only print flat to 5.4" and I wanted to...
The RPM relay turns the lambda system on by powering the "main fuel relay" (lambda relay). First is make sure that lambda relay is the correct type....
Oh man, that's unfortunate. I wonder if the block can be repaired by filling in the boss with aluminum (i.e. welded) and then tapped for a new bolt?...
The pilot bearing is not tight in the crankshaft holder, but if you are concerned about it slipping, you can use a bearing retainer ( Loctite 648 or...
It's mostly the pins that would require quite an investment to produce. Actually making little changes to pin design would enable the female pins to...
If your battery is good the first thing to check are the two feed through bolts and nuts behind the rear deck board. You have to remove the vertical...
Delorean was my dream car growing up and now I have 2. Trying to restore them the best I can. I live in MA and always looking for car shows to go to, to show them off. Keeping them as original as I can.
Find latest posts
