I just got the quick jack too. What model did you get? I got the 5000 pound one. It seeemd to have more room to position the rubber blocks than the 3500 pounder.
I just got the quick jack too. What model did you get? I got the 5000 pound one. It seeemd to have more room to position the rubber blocks than the 3500 pounder.
Ya I noticed that and had to decide over money and use and got the 3500 lb model. I really like it! Was worried about damage because it didn't reach the jacking points. Like I said with the rubber blocks no worries.
Dave B
I literally gasped out loud reading this. I was fully expecting to hear that the guy punched a jack shaped hole through the bottom of your car. You must have gotten really lucky that nothing bad happened. Did he use a flat piece of wood or anything to help distribute the load? Or the guy must have been far enough outboard where the fiberglass is thicker and wasn't on the actual seat pan. In some spots below the actual seat the fiberglass about 1/4" thick.
+1
Ok, so I'm planning on getting underneath to clean up the frame and stuff under there and was planning to get another set of jack stands (cant afford one of them fancy lifty things)...
I've never had a car completely up on stands before, so I'm wondering if there's anything i need to be paranoid of (other than a 3000lb car giving me a suddent weight loss treatment)?
Also..which end is best to jack first for less risk of the stands shifting or anything while jacking the other end?
Hi Rob,
I spent a few hours underneath my car when it was on 4 jack stands, it wasn't too bad, and you get used to it... As long as you have sturdy jack stands and place them correctly. Just ensure the car is on a level firm surface and you place the 4 stands in the same place as in the pictures in the first post ( and that your frame is solid enough for this). I prefer to use 2 floor jacks, one on each side in the jack points on the tub. I set the parking brake and lift the front end first, then position the jack stands under the frame, using a solid piece of wood between the stand and the frame as described. Next, ease the front down on the jack stands. Then you can repeat the process on the rear. I use the lowest setting on the jack stands to start off with, and then add more height if necessary, front first, then the rear.
I never tried to force a part off or "reef" on something while the car was on stands.
Thanks. I have acdelco stands...they were pretty sturdy when I had just the front end up.
Not planning on any wrenching of things under there...other than taking the gas tank panel off to make it all spiffy...most I'll be doing under there is using a wire wheel (and broom to clear out the dang spiders).
Mine spends about 6 months a year on 4 jack stands lol. Just put a piece of wood in between the stand and the frame to distribute the load and prevent scratching the frame.
I jack up the front end first because if I do the rear first I can't get my floor jack underneath the front spoiler. (Full disclosure: #2613 rides on Eibach springs from DMCH, so slightly lower than stock.)