Manual Transmission Not Shifting
Still can’t find 3th,4th?
Here’s some shots of 1st 1st picture then
Then neutral
(Note position of fork)
Am I missing something or is 1st really 3rd gear?
The car seems to pull forward in 1st and 2nd and reverse just fine
5th has a hard time (obviously) but hitting a stop on 3rd-4th
Only able to move it in the driveway due to rain/mud so can’t test it out
Sent from my iPhone using Tapatalkhttps://uploads.tapatalk-cdn.com/202...e2a886713b.jpg
https://uploads.tapatalk-cdn.com/202...994e899fb8.jpg
Manual Transmission Not Shifting
Quote:
Originally Posted by
Rich
OK.
Questions, assuming you don't want to wait for better weather to check the gear selections on the road.
With the current x-gate adjustment
1. Can you shift into R without lifting the shifter?
2. When you have the shifter in "5th" and notice the engine has a hard time have you tried to shift into "6th" (straight down from "5th")? In that case "5th" is really 3rd (which also lugs the engine from a stop).
The guess with these questions is that the shifter position is now better than before but the shifter now sits a bit too far to the right of the center position. Hard to tell with the black grease that's still in the left side of that notch the roll pin sits in.
See if you can get a small scale down into the shifter to measure the L-R location of the roll pin. Then adjust the x-gate to center it between the ends of the wide notch in the shift plate. That location should give you 3-4 without any L-R shift action and still leave room for 1-2 to the left and 5 to the right. It will not allow you to grab R without lifting the shifter so the pin clears the lockout.
I can’t get into R without lifting also No nothing below 5th I’m quite sure it’s in 5th gear but hey I could be wrong just nothing below and it’s way right where it should be
No grease in there it’s dried paint I’ll try and clean it up more but it’s actually really clean.
I’ll keep adjusting but I don’t think I ever had 3-4th with all the adjusting?
1st and 2nd are where they should be, same for 5th.
R 1st 2nd and 5th all work
Stumped
I don’t believe anything is broken because it did work before just very hard to get into and out of gears due to leaking (new) slave which I replaced and new lines just not the master
Sent from my iPhone using Tapatalk
Manual Transmission Not Shifting
Well I Drove the car today and after a few hours adjusting and getting what I thought was close
I can 100% unequivocally say I have NO 3rd and 4th gear!
There’s seems to be a lot play in 1st and 2nd almost to 3rd-4th so I drove it and was right unfortunately.
I replaced the bushing before this all except that one hard one
Suggestions cause I’m stumped
Sent from my iPhone using Tapatalk