Front end ride height & engine looks awesome!
Printable View
Front end ride height & engine looks awesome!
Thanks Man!
For those who are curious my suspension set up is drive stainless coilover kit, delorean club UK ball joints and lower aluminum control arms, dmc nos uppers, dmc rubber bushings and bearings everywhere except sway bar. I went with Toby from northwest poly sway bar kit. And got a set of trailing arm bolts as well. All of my brakes and components came from Mike at Midwest, he zinc plated everything for me but those are another days job. Gotta finish the suspension first. It's fairly strait forward. The drive stainless kit makes it easy. Front left took about 1hr and a half but had to figure things out and spent 30 minutes messing with the hydraulic press in the shop. Didnt even mess with the stock springs and a compressor just cut them....they were garbage anyway. Probably get the right front done in 30 minutes of course a lift makes things a lot easier.
Attachment 50099Attachment 50100Attachment 50102Attachment 50103
Got home from work tonight and rebuilt my calipers that I got back from Mike at Midwest . I don't think my wife will approve of my use of the rv kitchen table lol.
Attachment 50110Attachment 50111
Got origional sway bar, clamps, and front end recall brackets back from blaster and powder coat today just in time to be installed tomorrow. Plus this sweet clock from a fellow German membor.
Attachment 50478Attachment 50477Attachment 50476Attachment 50475Attachment 50474Attachment 50473Attachment 50472Attachment 50471Attachment 50470
Got a lot done this weekend. Front suspension is done. Rear supsension is almost done...left is buttoned up but the right rear hub bearing exploded when i tried to seat the axle so I need to fix that. The rear suspension was a huge pain in the ass....I have never seen bearings that bad and bushings that bad..I spent a lot of time pressing out the old bushings, but all the bushings and bearings are now new...I also replaced the trailing arm bolts and bushings...I got lucky because my bolts were actually ok but for piece of mind I replaced them any way. Also replace the accumulator, bolted up the eagle starter, and put a few sensors in. Pretty productive weekend. I highly recommend Drive stainlesses Qa1 Kit, quality stuff and easy install.
Jimmy
Attachment 50562Attachment 50561
Suspensions done...haven't made any adjustments yet. Stripped axles down and had the axles powder coated. Next up is rebuilding axles, installing brakes, clutch lines, brake master, clutch master and reservoirs.
Looks good!
Are your front & rear springs both grey?