Lol...thanks...guess I'll have to flip them...they are a pain to get the screws to lineup with the holes in the brackets..hehe.
Printable View
Lol...thanks...guess I'll have to flip them...they are a pain to get the screws to lineup with the holes in the brackets..hehe.
It's been a while got any updates for us ? I hope you have had some time turn a few wrenches. :wrenchin:
The last bit of snow is melting down here I'm ready to drive mine again:driving1:
Hehe...I'll prolly do a little in the next couple days....stay tuned :)
Lucky you, we didnt get snow, cept for one day...melted the next day...lol
Today I put the sunvisors on the correct sides..glad I dont have the seats in cause I'd hate to try and get in the right orientation to do those screws easily.
Also was going to replace some of the hoses on the coolant pipes, til I realized I'm gonna have to replace alot of the clamp things. Also noticed the hoses I got from DMC-H were like 3 inches longer than the ones that came off the car. Do I need to trim these?
Attachment 55648
I'll prolly go to Home Depot or Autozone to get new clamps tomorrow.
Top Tip... You probably should not use the standard hose clamps from Home Depot. The kind with the slits in the band do not provide even pressure and can cut into the hose and cause leaks.
Use something like these ...
Attachment 55650
Not these...
Attachment 55651
Cheers
Steven
Yeah, autozone is closer anyway. Probably tomorrow or the next day..didnt have a chance today.
Regarding the hose length, you shouldn’t need to cut them unless a particular joint would work better with a shorter connector hose. I’m thinking at the radiator there was one joint that benefits from being shorter due too a close bend near the pipe end, but my foggy recollection is 20 years old too. [emoji6]
Sent from my iPhone using Tapatalk
If I dont trim them, definately be too long once you figure in theres 4 on each side
Do whatever you feel is best for you.
Btw, that 1-1/4 Gates hose is a stock item at most auto parts stores.
When you cut the hose, a trick I use is too snug a hose clamp with one edge as the cut line. This makes an edge for the blade to follow. A break off blade slide type utility knife works well. Wet the blade with isopropyl or rubbing alcohol, it acts like a lubricant too let the blade glide through the rubber. The alcohol will evaporate fairly quickly leaving no mess.
Sent from my iPhone using Tapatalk
Thanks..I hadnt thought of using a clamp as a guide and the alcohol thing is a good idea too.