Pulled apart my steering rack to clean and check for wear, and I lost a damn bearing ball in the process.:tantrum:
Tomorrow, I will use a dial caliper to check the diameter of the balls and order a few new ones...
Printable View
Pulled apart my steering rack to clean and check for wear, and I lost a damn bearing ball in the process.:tantrum:
Tomorrow, I will use a dial caliper to check the diameter of the balls and order a few new ones...
Installed PJ Grady's adjustable clutch pedal clevis. as my pedal travel was too short due to the worn OE clevis/pins. no more 2nd or reverse gear grinds, and clutch bite point is no longer near the floor.
https://scontent-lga3-1.xx.fbcdn.net...0a&oe=5ADB33D5
Mock up #2. Still need to make a few adjustments and clean up but its close. After all this is done, both fascia's head to the paint shop! It might look a little off at the top as I'm holding on the Lex and pieces with tape so it might look a little off at the very tophttps://uploads.tapatalk-cdn.com/201...9cc6e99e1e.jpghttps://uploads.tapatalk-cdn.com/201...a87080c95d.jpghttps://uploads.tapatalk-cdn.com/201...6344fccc8d.jpghttps://uploads.tapatalk-cdn.com/201...d91f87d443.jpghttps://uploads.tapatalk-cdn.com/201...107079c5f9.jpg
Sent from my SM-N920P using Tapatalk
I went for a ride around town with friend of mine. nothing to exciting just cruising. I want to get my windows tinted I'm gonna hit up a local shop today after the wind dies down, it is blowing at about 45 MPH now.
Getting engine bay ready for paint....
Attachment 55370
Thats going to look nice when its all done! I powdercoated mine 6 years ago and holding up nicely!https://uploads.tapatalk-cdn.com/201...ce2b09b1ba.jpg
Sent from my SM-N920P using Tapatalk
[QUOTE=Christian Dietrich;231263]Thats going to look nice when its all done! I powdercoated mine 6 years ago and holding up nicely!https://uploads.tapatalk-cdn.com/201...ce2b09b1ba.jpg
Looks very good, clean!