I fixed the orientation of wires completely. I rerouted the large red wire near the transmission and the engine harness near the oil filter. Both wires are about 4" away from the manifold now.
-Rodolfo
Printable View
I know Josh has his hands full with personal matters right now, so figured I'd post this here...
I'm starting to install my DPI SPEC I exhaust and noticed I don't have the rubber exhaust mounts (P/N 105148} to accept the muffler studs. For those who bought DPI's set-up, did your kit come with these? My car was previously straight-piped so I don't have the old ones either.
Those mounting bushings used to around $10, now they are over $30 each. Maybe you can find some nice used ones.
Yeah saw the $30 and thought - yikes! I guess that supply is nearing the end at DMCH.
On another note, anyone know the torque spec on the header bolts/nuts (P/N 102441)? I've looked everywhere in this forum, my workshop manual and torque specs on wiki, but it doesn't have it listed anywhere. Looking at the torque specs for muffler support brackets onto the engine block for M8 x13, it has NM @ 22 / Ft.Lb. @ 16. I'm thinking with an M5 bolt/nut it would need to be a bit lower than that. Thoughts?
I just finished permanently installing the same system and I didn't use a torque, I just used "feel" rather. It would be impossible for me to get a torque wrench in there with all the crap I have on my engine in the way. I do have a book somewhere that has the torques I can post when I get home and look at it.
Sorry for the delay - one of my books says 13ft/lbs torque for the cylinder head/exhaust manifold nuts. The system does not come with the bushings nor manifold to cylinder head gaskets. I had a pair of new gaskets on my shelf from years ago that I used but it you don't have any - order them with the system.