Stainless air box

Printable View

11-09-2016, 10:04 PM
MNT250

Stainless air box

Purchased from another member awhile back never had a chance to put it on. Cleaning up the garage so time for it to have a new home! It doesn't have the bolts or washers but should be easy to pick up at the hardware store. I had a tinted plexiglass cut for it which cost me around $50 but I haven't installed it. Includes the original clear as well, which shows some wear but should clean up if you wanted to use that instead of the tinted. Asking $225 + $20 for shipping.

http://i.imgur.com/bGCCopH.jpg

http://i.imgur.com/Q4yS9tx.jpg

http://i.imgur.com/piwU6ld.jpg
11-19-2016, 12:45 AM
djdogbone

Question

Does it connect to the original air tube?
11-20-2016, 02:26 PM
Chris 16409

Message sent.
11-21-2016, 08:16 PM
Chris 16409

Is this still for sale?
11-22-2016, 10:04 AM
Jonathan

Quote:

Originally Posted by djdogbone

Does it connect to the original air tube?

I've wondered about how this connects too.

- does it use the original/black plastic lower half of the air filter housing, including the portion where the air filter goes as well as below that for the air intake all the way back to the pontoon?

- on the other side, where does the smaller diameter fume hose connect to on this unit (the one that plugs into the tip of the old housing with the other end of the hose coming from the oil filler contraption)?
11-23-2016, 11:10 PM
MNT250

Pending sale to Chris.

It does use the original air tube, and attaches to the lower half of the box that holds the filter. Not sure on the fume hose actually, didn't get that far.
08-19-2019, 04:36 PM
Bongiovi

Long shot but did this sell? Thanks!
08-19-2019, 11:05 PM
Chris 16409

I was the one that bought it.
08-20-2019, 08:02 AM
Bongiovi

Quote:

Originally Posted by Chris 16409

I was the one that bought it.

Gotcha, thanks Chris. I have been hunting for one for a while. Think I succeeded actually. How did you like it? Did you end up using the tinted plexi?