Originally Posted by
Bitsyncmaster
Ready to assemble.
Note the CV housing has a ring on one side. I don't think it matters if you flip it but on my car the side with ring is on the side without the boot. I've seen a few you tube videos that suggest to not put the same axle or same end back in the car the way they came out so the bearings may sit in a new "unused" spot. You can see a shinny spot where the bearing are mostly sitting.
Also my caps had some sort of "glue" on them to hold them onto the CV housing. It was a soft blue color "glue". I don't think you need any glue which was probably just so they did not fall apart in the parts bin.
I also did some measurements just in case you loose your "C clip" or someone installed a wrong axle.
Length of axle shaft = 21.11"
Distance from end of shaft to center-line of the boot clamp location =4.975"
C-clamp location dia. on shaft = 1.045"