FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com

Search:

Type: Posts; User: dn010

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds; generated 4 minute(s) ago.

  1. Thread: PRV Engine Block

    by dn010
    Replies
    0
    Views
    39

    [Wanted] PRV Engine Block

    I am in need of a good engine block: a B280F block from a Volvo 780 Bertone or the Eagle 3.0 block would be great if someone has acquired one for a swap but didn't end up doing it. The few blocks...
  2. Replies
    3
    Views
    257

    [Engine] Thanks, I figured as much. Seems any method of...

    Thanks, I figured as much. Seems any method of repair would cost more than it is worth with all things considered, so I'll have to look for a good block. Sucks because I sold a perfectly good block...
  3. Replies
    3
    Views
    257

    [Engine] Coolant Corrosion in Block

    Have have two PRV blocks, both of which were left with coolant standing in them for an unknown amount of time. The coolant has eaten its way towards the cylinder liner as you can see in the photos. I...
  4. Replies
    1
    Views
    160

    [Engine] Steel liner seals

    Disregard this question. Upon further inspection today, some of the metal shims are broken, so it?s back to paper!
  5. Replies
    1
    Views
    160

    [Engine] Steel liner seals

    When I am ready to reinstall the liners, can anyone tell me if I am fine to reuse the steel liner seals/shims that were originally on the liners when I removed them and should I use hylomar on them?...
  6. Replies
    16
    Views
    651

    [General] It would seem to me that all one would have to do...

    It would seem to me that all one would have to do is compare the weight of the new vs old.
  7. Thread: Dash pads?

    by dn010
    Replies
    9
    Views
    382

    [Frame & Body] Thanks for the insight fellas, I 'preciate it....

    Thanks for the insight fellas, I 'preciate it. Just dashes wants $2300 + shipping to restore the pad & glove box lid and while the money isn't a problem, the 4-5 month wait, is, and that is if I got...
  8. Thread: Dash pads?

    by dn010
    Replies
    9
    Views
    382

    [Frame & Body] Correct, looking for actual dash pad options. So...

    Correct, looking for actual dash pad options. So I guess it is either Just Dashes, DMCH or recovering the damn thing again.
  9. Thread: Dash pads?

    by dn010
    Replies
    9
    Views
    382

    [Frame & Body] Dash pads?

    I've been out of the loop for some time, and since I've been installing some electronics under the dash, I feel now would be a good time to replace the pad since the covering I originally put on it,...
  10. Replies
    27
    Views
    4,634

    [General] Wow....you do realize that lots of companies pay...

    Wow....you do realize that lots of companies pay marketing agencies and this is the result of what the marketing agency did, and not Josh/DPI - who I'm sure have nothing better to do, right?, did...
  11. Replies
    6
    Views
    1,210

    [Wanted] A ring gear is $180 + shipping, then all the work...

    A ring gear is $180 + shipping, then all the work to remove the old and install the new one and then balance. A refurbished flywheel is $300 so it might not make sense to go through all the ring...
  12. Replies
    6
    Views
    1,210

    [Wanted] I need a flywheel!

    :mad1:

    69249
  13. Replies
    43
    Views
    6,020

    [Engine] You don't mention what the fluid level was when...

    You don't mention what the fluid level was when this happened. Yes, there are linkage adjustments that can be found in the manual. One thing that helps a lot is to replace all the bushings throughout...
  14. Replies
    0
    Views
    2,744

    [Wanted] B280E/F Fuel Pressure Regulator

    Long shot I know, but I'm looking for a FPR from a Volvo B280F (1987-91 Volvo Bertone). Figured with conversion attempts someone might have one sitting around. I had mine rip on me so I installed my...
  15. Replies
    11
    Views
    2,071

    [Engine] I'd take the spark plugs out and disconnect the...

    I'd take the spark plugs out and disconnect the coil. Then crank it over and see what happens with the oil. Without compression, it will spin faster and reduce the drain on the battery.
  16. Replies
    50
    Views
    7,286

    [Fuel] I used gasket shellac compound, as suggested in...

    I used gasket shellac compound, as suggested in the CIS Rebuild PDF linked to post #2 of:

    http://dmctalk.org/showthread.php?352-K-Jetronic-System
  17. Replies
    11
    Views
    1,798

    [General] Unless it's 5% limo tint, leave it on. I think...

    Unless it's 5% limo tint, leave it on. I think almost all cars today come factory tinted, and it does make a difference with heat (I used to live in Sierra Vista AZ), less UV on your interior when...
  18. Thread: Prv v6

    by dn010
    Replies
    6
    Views
    997

    I see you've removed your eBay listing now. By...

    I see you've removed your eBay listing now. By the way, you can buy an entire 760 for under $1500 over here, $2100 (starting) over there (with 74KMI) so I'm not sure how an engine/transmission combo...
  19. Replies
    10
    Views
    1,960

    [General] Don't do it. I drove my D daily for years,...

    Don't do it. I drove my D daily for years, including winters, while living in upstate New York. The frame and everything bolted to it turned into garbage. The car was great in the snow, but terrible...
  20. Thread: Prv v6

    by dn010
    Replies
    6
    Views
    997

    The transmission would be useless to us and the...

    The transmission would be useless to us and the PRVs in the 760s are not drop in replacements for the DeLorean in that the lower crankcase needs to be changed. So a DeLorean owner buying your engine...
  21. Replies
    13
    Views
    8,374

    Did you try adjusting the pots to see if you can...

    Did you try adjusting the pots to see if you can resolve the loss? (If not, see VR sensor section of your hardware manual for the procedure)
  22. Replies
    21
    Views
    3,880

    [Heat & A/C] Post #10: ...

    Post #10:

    http://dmctalk.org/showthread.php?18967
  23. Replies
    6
    Views
    1,005

    [Suspension] Super stuck upper A-arm pivot bolt

    MAPP gas works wonderfully if you use it with a TurboTorch tip.
  24. Replies
    12
    Views
    1,807

    Poll: [General] ^Agreed^ 80% of the people who see the car...

    ^Agreed^

    80% of the people who see the car remember it "from that movie..." or it's "the Back to the Future car!", 5% know what it is from other experiences in their lives and 15% don't know what...
  25. [Engine] Take it out completely.

    Take it out completely.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4