Hi, I have same problem with the needle but very rarely in idle, mostly at 3000-3200 RPM.
Btw, my alternator is also delivering 12,5V with AC and Fans on and 14.0 with everything switched off.
Can...
Type: Posts; User: Azar
Hi, I have same problem with the needle but very rarely in idle, mostly at 3000-3200 RPM.
Btw, my alternator is also delivering 12,5V with AC and Fans on and 14.0 with everything switched off.
Can...
Hi there. After rebuilding the motor last year I have a motor failure. Suddenly heard loud scraping noise from the right side of the engine. Took the valve cover off just to find pieces of white...
Was nice meeting you and your wife and chatting over the dinner and bier, Jakob!
Hope will meet again soon at the DeLorean annual meeting in Berlin!
Have a safe...
Very good write up. Following this rule when I am in US.
In Germany we (usually) don't have this since we must drive in the most right lane if it is empty / there is space and overtaking on the...
Hi Jakub, you did not answer to my post about Kassel. Should we expect you?
This app.
Ok understood, will do :)https://uploads.tapatalk-cdn.com/20220425/a99dcbd13f2b3ca07ae4af981dc69f0e.jpg
Thanks Thomas, I already have an app and my VIN and information is there. But looks like I need to create account and password to be included and search the smaller owners list. Will do!
BTW, I...
Hey, you are welcome to visit us in Kassel. It is exactly on your way. Wow, 2300 Km! We have tools here and mechanics in case if anything breaks down.
Azar
+491623813639
Hi! Where exactly on the photo the wear is bad? The one touching the valve or the side sliding in the camshaft? Thanks!
I am sorry, looks like I missed your question...
I just put silikon on the inner O ring and pushed the Flange in.
Yes, this was the behaviour before rebuilt with the only difference - the warning light started flickering after 30 minutes drive.
Yes, I have marked the dates in the calendar for the Berlin meet...
I need to dig in to the records but the manual gauge connected directly to the motor instead of the dash sensor showing good pressure. The dash sensor is showing low when warm but the light is not...
Directly from where? DMC Houston, California, Florida...
Yes, last year replaced the fuel accumulator and now starts immediately!
Yes, finished motor rebuilt in September, ran 1000km and changed oil, 20w-50. Now in the winter storage since 1st of Nov, waking the baby up in just 2 weeks!
Same question. I have the history only from 2010. Would really love to know the history!
Hello, where can I get the 3D drawing? Thanks!
I like it! Thanks for sharing!
Thanks. Did not know that this was a part installed later. My car 05257 has it. Probably was installed by DMCH.
Sounds to me your RPM relay losing signal after you finish cranking and motor is starving for fuel...
I have exactly same problem here....
Top corner of the door seems fine, mid part is lot lower than the fender and even below the windshield....677466774567747
67748
The correct technique of shutting the door is not the middle of the door from outside or strap. The strap is only to pull it down. You have to shut the door pushing where the handle out side is. And...
Mine was in bad shape (the fils part was gone) so I just brought one from DeloreanGo and installed it. No issues since. I definitely did not glue it...
Thanks, checked with the Diagramm already. The other one is 12V [emoji2]
Thanks Dave, did as you instructed. The 3,5mm thick O-Ring which I retrieved had some old white silicone on it. So I have installed new 3,5mm thick O-Ring and put black silicone on it. No leak for 10...