FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com

Search:

Type: Posts; User: Chris4099

Page 1 of 19 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    150
    Views
    42,657

    Mario, I assume this is your D in the recent...

    Mario, I assume this is your D in the recent Fully Charged visit to EV West?


    https://youtu.be/mOx5uCufB2Q?t=728

    It will be cool if they end up developing a bolt-on DeLorean conversion kit out...
  2. Replies
    29
    Views
    1,561

    [Fuel] How old are the PPR O-rings? They are cheap and...

    How old are the PPR O-rings? They are cheap and easy to swap out, so I would try that first (especially if the current age is unknown). Assuming the check valve is confirmed good at the pump, then I...
  3. [Electrical] I had this issue too. For me, I simply added a...

    I had this issue too. For me, I simply added a spare relay to the brake circuit (I did this at the cruise controller wiring harness). When I press the brakes, it powers the relay coil. The coil alone...
  4. Very cool. Hopefully the motor inside that unit...

    Very cool. Hopefully the motor inside that unit lasts a long time. Can you hear it while driving or does the engine and road noise cover the sound it makes? I also assume you got the GM clip-on...
  5. Replies
    12
    Views
    1,086

    [General] Now that I'm home and can look at the video full...

    Now that I'm home and can look at the video full screen, I'm still not sure it's John's pump. He had the "power pump" which was smaller then the factory one but wasn't intended to go to the stock...
  6. Replies
    12
    Views
    1,086

    [General] That was a factory setup in there, not John's....

    That was a factory setup in there, not John's. You can see the stock pickup assembly and hose inside the tank. It appears the pickup hose broke and was repaired in some odd way instead of replaced....
  7. Replies
    9
    Views
    928

    [Engine] I can't recall where I read it, but the Bosch...

    I can't recall where I read it, but the Bosch K-Jetronic version was already tested and approved for use in the US. So by going with that version, it was a much faster and cheaper process to get the...
  8. Replies
    12
    Views
    863

    [Electrical] I believe it's pins 30 and 87. One should be...

    I believe it's pins 30 and 87. One should be going to a 12v positive and another to the wiring that runs to the solenoid in the door. Normally you don't want to just short these two pins with a small...
  9. [General] Are the horns the original factory ones? If so,...

    Are the horns the original factory ones? If so, they are probably just worn out. I went to Autozone and picked up a cheap high/low pair and just swapped out the original ones. Simple and easy to do...
  10. Replies
    32
    Views
    2,136

    [General] Just to throw in my 2 cents. In 15 years of...

    Just to throw in my 2 cents. In 15 years of ownership, I've never had matching tires. And in those 15 years, only a handful of times people have noticed the mismatch. Those people: DeLorean owners...
  11. With the movie now on Blu-ray, I was able to do a...

    With the movie now on Blu-ray, I was able to do a lot of freeze framing to make out a lot of what's going on. When he deploys the car before the race, I took a very close look and was astonished at...
  12. Replies
    32
    Views
    5,916

    [Engine] Ed, Honestly, I can't remember exactly how I did...

    Ed,
    Honestly, I can't remember exactly how I did it as it's been about 8 years now. I can say I didn't use any power tools, just a standard hammer. Since it was rust holding it on, I probably just...
  13. Replies
    10
    Views
    1,088

    [General] Yes, that pic is of a first gen Stage 1 from DMCH...

    Yes, that pic is of a first gen Stage 1 from DMCH that rusted like that (wasn't made of SS). I have a DPI Spec 1 for about 8 years now that's not coated. Obviously doesn't look as nice, but there's...
  14. I saw the movie last night. Loved it! Very fun...

    I saw the movie last night. Loved it! Very fun seeing Ecto-88 in it (granted without the Ghost Busters logo probably due to not being able to get rights). Sure it was all CGI, but it was very well...
  15. Replies
    15
    Views
    1,414

    [Electrical] Is this for the door lock actuator conversion? If...

    Is this for the door lock actuator conversion? If so, contact Toby. He used to make an additional harness adapter that would plug between the stock lock module and car harness (it's been a few years...
  16. Replies
    11
    Views
    1,378

    [Electrical] Tough to say, depends on the SME type. If you...

    Tough to say, depends on the SME type. If you can, see if they list the lumen output. At least 200 is good, closer to 300 is best. The real safety aspect of LED brake lights is the instant on which...
  17. [General] Looking at the http://delorean-parts.com/ web...

    Looking at the http://delorean-parts.com/ web site, they show most of the kits are available. Not sure how accurate the online inventory counts are though. You can always order and see what happens....
  18. Well, because of this thread, I decided to go out...

    Well, because of this thread, I decided to go out and get this book as I've been on vacation this last week. I read through it in just 6 days which is really fast for me. While a bit predictable and...
  19. Replies
    21
    Views
    2,961

    [Brakes] I had a similar issue. What I did both on my D...

    I had a similar issue. What I did both on my D and another during a tech session was to put the nut back on, but only a few threads. This gives you a large surface to hammer against. I then took a...
  20. Replies
    60
    Views
    10,187

    [General] I thought of this right away. Pretty much every...

    I thought of this right away. Pretty much every country in the world requires a rear license plate which would cover the M. So all these new DeLoreans will say DC on the back! :rolleyes: Hopefully...
  21. Replies
    72
    Views
    12,109

    I just purchased two of these (but sadly have...

    I just purchased two of these (but sadly have since sold out):
    https://www.amazon.com/gp/product/B06XR82RKD

    At $70, it has all the major features and remarkable resolution (major factor in dash...
  22. Replies
    13
    Views
    2,213

    [Electrical] I've installed these bulbs in 3 different...

    I've installed these bulbs in 3 different vehicles now. I really like them because they have no cooling fan that can get jammed up with time. On my MINI, they worked perfectly and the beam pattern...
  23. Replies
    13
    Views
    2,213

    [Electrical] Here's a thread I made on using H4 housings with...

    Here's a thread I made on using H4 housings with LED bulbs:
    http://dmctalk.org/showthread.php?13455-LED-Headlight-Conversion

    Long story short, the beam pattern was terrible and required some...
  24. Just the opposite. I'm trying to say Tesla is no...

    Just the opposite. I'm trying to say Tesla is no different and shouldn't be singled out like they are here. Like it or not, many modern cars will trap you in the event of an electrical failure. Not...
  25. OK, I'm not seeing the bid deal here on the 3rd...

    OK, I'm not seeing the bid deal here on the 3rd row either. Most vehicles with 3rd row seating don't have dedicated doors for those seats. Does that mean all cars with 3rd row seating are now death...
Results 1 to 25 of 460
Page 1 of 19 1 2 3 4