Hey Darren, As it turns out, I will not be attending this weekend. We have an annual car show here in Charleston this weekend, the Doo Wop. A friend of mine has been sick and needs help getting his...
Type: Posts; User: yianni
Hey Darren, As it turns out, I will not be attending this weekend. We have an annual car show here in Charleston this weekend, the Doo Wop. A friend of mine has been sick and needs help getting his...
Thank you all for this information. I did what you all suggested first (jumping black, with black/blue wire) and car fired up just like it use to and ran fine. Then I checked for continuity from the...
Found out that Alfa Romeo uses same TTS so I pulled mine out of my Spider that I know works and plugged it into the D but still didn't fire up the CSV, maybe wiring problem or something that am not...
Similar problem with my car, after replacing fuel lines my car wont start when cold. Did the plug swap to csv all good there wire read good with meter have 9.8v on csv plug while cranking cold. David...
Ok then, I learned that my lines do swivel if I force them. And maybe an adjustment on the fuel mixture if needed. Thanks again for all the good info and thank you Josh for your advice also.
No, I didn't check the mixture with the new lines. I didn't even think about it, what I found, that most of you know, was the end fittings on the lines are on the same plane and not offset which put...
I don't know if I'm wiling to go through that again sense my old lines are working properly. I will talk with Josh and see if I can return them or get credit for something else in the future that I...
Problem solved, got my car running again. Spent two hours today pulling out new lines and replaced with the old existing ones. I don't know why, but it likes the old ones. After a couple of cranks it...
I just replaced my fuel lines today and am having the same problem -- car won't start, but was fine prior to replacing lines. I pulled out injectors and no fuel is spraying. My fuel lines also came...
Has anyone replaced the seals under the reservoir in the master cylinder? My seals gave out already after 2 years. Is it an option just to replace seals without replacing the entire MC? It's been...
My mc started to leak between seals and reservoir. Is this a mc failure or seal failure? The mc is two years old from DMCH with my original tank. Do I have an option here just to replace seals, and...
I will be leaving from Charleston WV. to the car show, I can meet with anyone here (if traveling from the south) or we can meet along the way. Just let me know. Yianni
Hey guys, I have removed my transmission for the third time, I had a rear main seal leaking. The first time I used a DMC seal and the second time I used a John Harvey seal. I don't know if I had bad...
Totally agree with you. Darren is a great host and a Delorean enthusiast. I have attended two of his shows and they were great. As a matter of fact, that is where I heard my D run for the first...
I found mine broken also when I replaced the clutch. I checked around and couldn't find one without going to the big shops and paying big money for a four inch clip so I fixed my old fork with a new...
Darren, Thanks again for the invitation. I would like to attend, but I have a conflict with the earlier date. May 16 should work for me. Would like to bring my car down and have some of the guys...
Putting scratches on the shaft with sand paper would be difficult in such close quarters, but some permatex sealant on the edge of the o ring and flange splines might do the trick. That's what I'm...
Thank you everyone for all the good advice, O ring will be changed.
[/QUOTE]
Thanks for the response. Leak is definitely not from seal. I wiped it a couple of times and watched it drip from inside the split pin. Seal and stainless sleeves were purchased from...
After car sat for most of the winter, I noticed an oil leak. After investigation, it is coming from transmission right flange split pin. Has anyone had this problem or have advice for how to...
Darren, Thank you for the invitation. I would love to attend if I can get away. I will be heading back from a work trip in NC on October 11. Hopefully, things will work out and I will be able to...
Unplug the mirror switch, take a jumper from the light green wire to the violet wire. Then, another jumper from black (ground) to dark green wire. Your driver side mirror should move in up motion. ...
Thanks for the response Dave, but when I tried to order the switch, it was not available and you didn't know if or when it would be. Therefore, this was my next best option. I purchased a dummy...
Original mirror switch went out and I am trying to use the Saab switch mentioned in this thread. Has anyone done this recently and have a wiring diagram or pictures? The old switch has 8 wires, but...
Thanks for posting this. I have been looking for rear louvers that are better than mine. If they need a small repair, I don't mind dealing with that. Let me know what you have available and the...