Indeed you may have gotten a bad one from the "nest".
Mine is on the car since 2008 and still good.
Type: Posts; User: WelmoedJ
Indeed you may have gotten a bad one from the "nest".
Mine is on the car since 2008 and still good.
I agree with Dave S.
Firstly check the injectors.
If you never have exchanged them and the car has been sitting for some - long - time the injectors may have acquired rust (making small pits in the...
As I do not know B-12 I haven't replied to judge it.
I however can add to my previous entry:
The nut securing the cylinder in place can also cause issues that show up as a very difficult movement...
Reading you having a lot of electrical gremlins tormenting you, I wonder if you ever have taken the time to check all ground connections.
Not only those for the battery, but also those in the relay...
Disconnect the injector from the fuel line and see if it "pisses".
If it does, it's the injector (clogged or stuck closed), if it doesn't it's the fuel distributor not performing as it should.
...
If you feel more comfortable trying without removing the mixture unit, why not.
Removing the mixture unit involves:
- disconnecting the auxiliary air pipe (disconnect the ISM to make it easier to...
Thanks for the info, Rob.
The pipe's fit is no issue at the moment.
I now know where to get it, once I need to work in that area again.
For now I stick to the phrase "If it aint broke, don't fix...
You don't have to disassemble the mixture unit. You do have to take the mixture unit off, to put the brass "cup" and O-ring into place.
It may help to bend the outside ring of the cup a bit outward...
You can test those devices: turn the alternator by hand and feel if there are moments you have resistance, pointing to a bad bearing.
You can apply the same test to the waterpump.
Both test...
Although the hose isn't dedicated to the job, I used a fuel hose that has outside re-inforcement.
Fits okay and sits there since 5 years.
No leaks, no sweat.
Use the info on the GM diagram.
The Delorean door ajar switch is between buzzer and ground on the ignition key (with NO key inserted).
So two switches in one circuit, also being powered at the door...
No, there's not a plug and play replacement.
However I've used a GM chimer module used in a Pontiac TransSport (model 95).
For that chimer I written a How To.
Some other owners have used GM...
IMO the info in the Owner's Manual is incorrect, at least regarding the passenger seat.
The "seat belt warning system" also doesn't detect occupation of either seat (no detection device in the seats...
The most known reason why it's called the Pipe of Agony is because it's giving most owners a hard time to get it in place correctly.
However once familiar with the pipe's behavior and knowing the...
My dash at the time of purchase had been severly damages by cracks in the vinyl.
I therefore stripped all the vinyl, repaired the cracks in the softer material that covers the metal dash plate.
...
Thank for the info, Bob.
Haven't meant the site to be able to scale.
The site has been developed to work at the old 800x600 dpi, no scaling.
Nowadays resolutions are much higher and people tend...
Further to this remark:
I've been hunting down the bugger and killed it :)
No Chrome specific issue, merely a flaw caused by copying an exsisting menu and making changes.
By overlooking certain...
Thanks for your input.
There always are flaws to pay attention to and try repair.
I haven't checked Chrome's behavior as I am not using that browser.
Sometimes even IE behaves badly, but I'm...
Our website (deloreancarprojects.com) is totally refreshed and updated.
This is the place to find special products and accessories.
The manufacturers we represent are DCP (Netherlands), McKeen's...
Behind the grille - in the middle - there should to be a 90° angled flat strip to push up the facia.
Was missing in my car.
Fortunately a lot of the thread starter Jonathans list is still...
Tom was able to get out of the car in one piece.
The picture shows him behind his car.
No info on the truck driver's furtehr actions (stopping, exchange insurance info etc).
From the stories...
My friend Tom's car.
A truck driver passed him at the right hand side, looking at the car.
While looking he steered to the left and pushed Tom's car right in front of an oncoming Toyota.
The...
Racerx also mentions "loss of power".
So the rattling and this loss of power make on think more engine related than merely bracket problems.
Since it's an automatic the pressure regulator could...
Use a timing light, or an old spark plug (not the one in there) and plug wire for cylinder 1.
Should be a quicky that way.
The third picture (with the steering wheel) shows part no 1 (mounting plate/support plate for buzzer, wiper relay, DI relay).
If this is your bugger, then the picture shows how to mount this plate....