Search:

Type: Posts; User: DMC5180

Page 1 of 20 1 2 3 4

Search: Search took 0.10 seconds.

  1. Thread: A/C Pulley

    by DMC5180
    Replies
    8
    Views
    134

    [General] You just refreshed my memory of this very issue. ...

    You just refreshed my memory of this very issue. When I got my car way back when, it was missing the upper pulley and bracket. The belt created a notch 70% into the wall of the hose. I was lucky I...
  2. Thread: A/C Pulley

    by DMC5180
    Replies
    8
    Views
    134

    [General] A/C Pulley

    I stand corrected, it is CW. I just watched a video in another thread of the engine cranking over.

    Thanks Ron [emoji106]



    Sent from my iPhone using Tapatalk
  3. Thread: A/C Pulley

    by DMC5180
    Replies
    8
    Views
    134

    [General] A/C Pulley

    The upper pulley is on the slack side based on CCW rotation when viewed from the rear. Ever time the A/C engages along with power pulses from the pistons there is a momentary loosening on the upper...
  4. Thread: A/C Pulley

    by DMC5180
    Replies
    8
    Views
    134

    [General] A/C Pulley

    Itís a fairly long distance between the crank pulley and compressor. My guess is they where trying to limit belt whip and the potential for throwing the belt off.

    The upper pulley is fixed while...
  5. Thread: Cold Idle

    by DMC5180
    Replies
    41
    Views
    674

    [Engine] The question was more in regard to your wording. ...

    The question was more in regard to your wording.

    Pressing and depressing can be interpreted as the same Action.

    Using the term Releasing the switch would have been a better choice.

    In your...
  6. Thread: Cold Idle

    by DMC5180
    Replies
    41
    Views
    674

    [Engine] Okay, New ISMís donít usually fail. Old oneís...

    Okay,

    New ISMís donít usually fail. Old oneís can suffer from Rust in the bearings or carbon build up in the valve end.

    I think you should At least pull the short connector hose off the ISM...
  7. Thread: Cold Idle

    by DMC5180
    Replies
    41
    Views
    674

    [Engine] Under warranty? Please tell us the history of...

    Under warranty? Please tell us the history of your vehicle ownership.


    Sent from my iPhone using Tapatalk
  8. Thread: Cold Idle

    by DMC5180
    Replies
    41
    Views
    674

    [Engine] Cold Idle

    to clarify, the Warm up regulator does not get power with the key in RUN, only if engine is running. Which you already verified.

    This is normal. You will not have power without the engine running...
  9. Thread: Cold Idle

    by DMC5180
    Replies
    41
    Views
    674

    [Engine] Cold Idle

    I would verify your ISM is not Stuck first.

    You can move (pivot) the cold start valve tube toward you about 1/2 inch. This is usually enough to slip the short connector hose off the ISM. Push the...
  10. Thread: Cold Idle

    by DMC5180
    Replies
    41
    Views
    674

    [Engine] Typically the when unplug the ISM while at idle...

    Typically the when unplug the ISM while at idle it will stumble or die completely. Not always though it is a bit condition dependent.


    Sent from my iPhone using Tapatalk
  11. Thread: Cold Idle

    by DMC5180
    Replies
    41
    Views
    674

    [Engine] How does depressing the Idle micro set the speed...

    How does depressing the Idle micro set the speed to a higher level?




    Sent from my iPhone using Tapatalk
  12. Thread: Cold Idle

    by DMC5180
    Replies
    41
    Views
    674

    [Engine] Cold Idle

    Correct. (The heating element) within it.

    Just thought of something, make sure the idle Micro-switch is depressed when you have the key in the run position. This is the ground for the Idle ECU to...
  13. Thread: Cold Idle

    by DMC5180
    Replies
    41
    Views
    674

    [Engine] Your RPM relay is probably fine since the engine...

    Your RPM relay is probably fine since the engine runs. Fuel pump is working.


    Sent from my iPhone using Tapatalk
  14. Thread: Cold Idle

    by DMC5180
    Replies
    41
    Views
    674

    [Engine] Cold Idle

    The WUR (heater element) is only live with engine running.

    The ISM should run (vibrate) with key In Run.

    What is your current ambient temp?

    Sent from my iPhone using Tapatalk
  15. Replies
    91
    Views
    31,027

    Vin 11408, LS Swap

    Josh,

    Just curious why you went with a steel spacer plate vs aluminum? Did you make a new flywheel? I do find pretty amazing that with the spacer it, it looks like the axles end up in the same...
  16. Thread: Cold Idle

    by DMC5180
    Replies
    41
    Views
    674

    [Engine] Turn the key to Run without starting and put your...

    Turn the key to Run without starting and put your hand on the ISM. Does it vibrate?


    Sent from my iPhone using Tapatalk
  17. Replies
    7,114
    Views
    945,638

    [General] Dana, Please, please, bring your D to DCS...

    Dana,

    Please, please, bring your D to DCS 2018. [emoji1317]
  18. Replies
    37
    Views
    1,477

    [Electrical] https://www.snopes.com/autos/techno/battery.asp ...

    https://www.snopes.com/autos/techno/battery.asp



    Sent from my iPhone using Tapatalk
  19. Replies
    37
    Views
    1,477

    [Electrical] You Drive your car enough, with continuous fresh...

    You Drive your car enough, with continuous fresh fuel, that you really donít need to worry about adding fuel stabilizer. It certainly doesnít hurt anything, but donít feel bad if you didnít...
  20. [General] Trunk Carry - or - What tools and items should you always carry in the car?

    For me it depends on the trip.

    I carry my spare OE fuel pump. I replaced it 17 years ago as a preventative measure. It still works and Iíve bailed out a buddy with it when his non - bosch...
  21. Replies
    29
    Views
    2,044

    Electrical Harness Replacement.

    Whether they are needed or used is not really the point. My personal reason for installing the mirror heaters was to complete what was originally intended by the factory. The downside with using the...
  22. [Electrical] I would tend to agree and was thinking about that...

    I would tend to agree and was thinking about that earlier. The trace tab for the illumination lights would need to be displaced a lot though. So much so that it doesnít make contact with the normal...
  23. [Electrical] Something got miss wired. Have you done any...

    Something got miss wired. Have you done any electrical work behind the A/C panel. I saw you mentioned having the center console out at some point. What was the purpose of that?


    Sent from my...
  24. [Electrical] When you say flash the dash lights, do you mean...

    When you say flash the dash lights, do you mean cluster illustration dips down but not off?


    Sent from my iPhone using Tapatalk
  25. Replies
    29
    Views
    2,044

    Here is the partial install with the signal wires...

    Here is the partial install with the signal wires Red & Black.

    https://uploads.tapatalk-cdn.com/20171219/b6d511ffe6c3e726a033aec24d98c924.jpg


    Sent from my iPhone using Tapatalk
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4