FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com

Search:

Type: Posts; User: cpistocco

Page 1 of 14 1 2 3 4

Search: Search took 0.01 seconds.

  1. [For Sale] parts?

    Hello
    Would you have a set of louvers? or a grey glove box?
    thanks
    Charlie
  2. You're welcome.... I thought that this would be a...

    You're welcome.... I thought that this would be a nice place for the info.
    And- Yes...for sure... My vacuum solenoid was allowing vacuum to the distributor at idle. Wreaked havoc with my...
  3. How To: Checking timing (timing is everything)

    Credit to David T for this-

    If you need the step-by-step procedure( for checking engine timing) here it is:
    Disconnect and plug the vacuum line to the distributor vacuum advance capsule.
    Clean...
  4. Thread: Bttf parts

    by cpistocco
    Replies
    2
    Views
    484

    Yes- What do you have? :)

    Yes- What do you have? :)
  5. Replies
    3
    Views
    534

    [Wanted] Thank you.... :)

    Thank you.... :)
  6. Replies
    10
    Views
    376

    Crazy question....If you remove electrical...

    Crazy question....If you remove electrical connector from Vacuum advance solenoid, do your rpms go down...and does that close off vacuum to the advance on distributor? (I am far from a Delorean Guru)
  7. Replies
    3
    Views
    534

    [Wanted] glove box lid

    Looking for a glove box lid. Grey. Seems like the only thing available now are reproductions.
    Has anyone tried the repros yet?
  8. Replies
    10
    Views
    376

    vaccum advance at idle

    I had a problem where my car would stumble/ detonate/ knock from a dead stop. Happened only when warm. After fiddling around, (and with some help from Dave and DMC Humble) I found that my micro...
  9. Replies
    7
    Views
    282

    fun filled fact

    Here is a Fun-filled-fact concerning rpm Relay (and any other relay, for that matter).- Relay should ALWAYS be in the upright position (wires down) to work properly.
  10. Replies
    56
    Views
    8,618

    [General] Thanks again, everyone, for all of the help. :)

    Thanks again, everyone, for all of the help. :)
  11. Replies
    56
    Views
    8,618

    [General] Cleaned it, sprayed it with degreaser, cleaned it...

    Cleaned it, sprayed it with degreaser, cleaned it again, and epoxied it...and prayed.
    I will let everyone know when it fails... :)
  12. Replies
    56
    Views
    8,618

    [General] column bushing / grommit

    Thanks Guys...
    I think that maybe the hole in the firewall got sloppy from not having a bushing....and now the new bushing isn't seating tightly. To make matters worse, I had greased everything...
  13. Replies
    56
    Views
    8,618

    [General] When you turn the steering wheel, the bushing...

    When you turn the steering wheel, the bushing should not turn, right?
    Has anyone ever tried to hold the bushing with a sheet metal screw on either side, 180 Degrees apart?
  14. [Electrical] Automatics seem to fit differently.......

    Automatics seem to fit differently....
    Also...one spring clip (toward the rear), has nowhere to go.
  15. Replies
    100
    Views
    50,648

    My Pleasure...

    My Pleasure...
  16. Replies
    30
    Views
    4,769

    You could have bought one at Barret Jackson...

    You could have bought one at Barret Jackson today...charity auctioned Delorean went for under 25k !
  17. Replies
    100
    Views
    50,648

    I have a bodyshop/ repair garage in RI. I work...

    I have a bodyshop/ repair garage in RI. I work on my own Delorean all the time. I could take a look at it for you... Maybe you have an air pocket, bad water pump, Radiator fan issues. thermostat...
  18. Replies
    100
    Views
    50,648

    Framing John

    Hello fellow New Englanders. There will be a screening of "Framing John Delorean" in Newport/ Portsmouth RI on Thurs night 6/27.
    Please see link-
    ...
  19. Newport or Portsmouth?

    Newport or Portsmouth?
  20. Replies
    0
    Views
    689

    How To: Changing Automatic shift cable

    There is NOTHING out there addressing this topic- So here goes...
    First- Credit to Steven and Dan at DMC...

    Tools required-

    Ratchet
    Ratchet extension- approx. 3 inches long
    13 mm socket
    17...
  21. Replies
    13
    Views
    1,186

    [General] Paints can blush with high humidity...esp fast...

    Paints can blush with high humidity...esp fast drying paints.
  22. Replies
    1
    Views
    376

    [For Sale] high end front speakers

    I have a set of new front speakers....Never used.....In box.
    $75.00
  23. Replies
    1,072
    Views
    316,422

    Not sure if this is too naughty....but WOW!

    http://bodypainter.com/bttf
  24. Replies
    33
    Views
    4,629

    Coolness!

    Coolness!
  25. Replies
    19
    Views
    1,716

    [Suspension] I would like to copy your look (with your...

    I would like to copy your look (with your permission). :)
    Can you give me your specs?
Results 1 to 25 of 350
Page 1 of 14 1 2 3 4