Probably could do for a rebuild considering its age. Worked prior to me removing from vehicle. Make me a reasonable offer and it?s yours plus shipping (or local pickup in Flemington, NJ)69556
69553...
Type: Posts; User: sztybel
Probably could do for a rebuild considering its age. Worked prior to me removing from vehicle. Make me a reasonable offer and it?s yours plus shipping (or local pickup in Flemington, NJ)69556
69553...
I am pretty curious myself as to what happened with inventory. Obviously John had years of knowledge on his web site as well. I have been accessing that part through archive.org
Sent from my...
The cable was bad and I've tried to repair the area with a new cable, but the actual LCD screen board is coming apart. So I just need that whole piece and then I can run a new cable. So if anyone has...
I am looking for Craig w460 radio part. Even if your radio is toast the only part I really need is the screen. Anyone have something like this laying around?
I went with the Volvo 760 (022) injectors.
Sent from my H1A1000 using Tapatalk
Update on the bogging down issue: It is gone. I ended up replacing the injectors after we discovered they were so gunned up with crap that the fuel wasn’t getting through them properly.
The car...
Today we checked the vacuum and timing. All was good there.
However when we started checking the fuel injectors we noticed a bad spray pattern on the first two we pulled out and checked.
Does...
I see. Thank you for the tips!
Sent from my iPad using Tapatalk
Am I hooking the disconnected vacuum line to a vacuum gauge or just feeling the vacuum solenoid for actuating in the instances described??
Sent from my iPad using Tapatalk
So was your vacuum solenoid stuck?
I have the air box off the car and the micro switch is right there. How did you know that part was no longer doing it's job?
Sent from my H1A1000 using...
I ran the dwell meter last night. When the car first started up it was about midway on the meter and then dropped to zero within about 15 seconds. The weird part is I can still hear the frequency...
I am going to check it again tomorrow. I was so focused on the dwell dropping to zero that I neglected to check if the frequency valve was still buzzing. It's possible that it did stop buzzing though...
I just hooked up the dwell meter and it was reading right around 20 during idle. Then it dropped to 0. This was before the car reached operating temperature.
Any ideas on what could be the issue...
The latest update is I looked at the two areas where the banjo bolts connect to the WUR. The screen was pretty gummed up and I got that cleaned out. Car is running noticeably better, but still...
The bogging down seems to be consistent across the board whether the car is hot or cold. It will do it while revving but nowhere near as noticeable as compared to driving it.
Sent from my H1A1000...
Good afternoon, folks,
I have been doing extensive work on my car over the past several months. Primarily the fuel system. In any case I've cleaned out the entire fuel tank, replaced the fuel...
I watched it (rental) between yesterday and today. I thought it was great. I would definitely like to see more of the trial in the movie. For all the surveillance leading up to the trial portion it...
Yes, these are the "horns" or W. The real part name isn't either though. Ha ha!
Now on eBay: http://www.ebay.com/itm/291707472811?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
Used intake manifold (part number 102260) and tubes for manifold (part number 102279) No...
Just added a rear wheel off my 1981 on eBay:
http://www.ebay.com/itm/291707459859?item=291707459859&viewitem=&sspagename=ADME:L:LCA:MOTORS:1123&vxp=mtr
I listed the t-panel at a very low starting price and took photos of the areas that need minor attention.
...
I have no shame, so it'd be hard to shame me off the forum. Ha ha!
Yes Rob and I spoke about the problem last night. I trust he knows what he's talking about regarding the bent bracket. Honestly I...
It's been ages since I logged on here but I have been getting back to working on my car.
The problem of today is that the passenger side window is out of the car due to it slipping off the guides...
I love my DeLorean, but comparing it in any way, shape, or form to a Ferrari is just plain silly. :driving1:
I feel like the wine at least gave the impression of a high class brand. The bike just seems cheesy. But then maybe it would go great with wine. WACCA WACCA!