Will DeLorean make it?
Was my main concern on the way.
Turns out DeLorean is fine, DeLorean is perfect, there is nothing wrong with DeLorean. It’s a squishy, fleshy thing between seat and...
Type: Posts; User: Jakub
Will DeLorean make it?
Was my main concern on the way.
Turns out DeLorean is fine, DeLorean is perfect, there is nothing wrong with DeLorean. It’s a squishy, fleshy thing between seat and...
Another DeLorean on the way.
Not far from Robin Hood and Sherwood Forrest.
68488
68464
Pretty self-explanatory.
68465
Ragley Hall Alcester Classic Car show last Sunday.
Best overheard comments.
Gentleman to his wife: This is car from Saudi
68450
Making friends on the way. Kassel, Germany.
Making movies? At certain age operating phone camera comes with difficulty.
Anyhow we are on the road. Departed yesterday. 300 miles gone, another 3000 to go.
Either it's different Derby or it's almost on my way. If things will go according to plan we should be there Monday or Tuesday May 10th ot 11th. Since VIN of our DeLorean's differ by less than 100...
Hello Chris,
I am planning as follow – Channel tunnel, London, Redditch (I am also Royal Enfield owner), Holyhead.
And on the way back Cairnryan, Edinburgh, Hull.
As for factory my...
[QUOTE=Citizen;271304]Jakub,
As you are already member of the DOD, you have at hand a list of DeLorean Owners around the world. The current DOD shows owners in the following countries that have...
I am planning to visit Dunmurry mid May. Driving both ways from Warsaw, Poland. Perhaps my plan is a little bit too optimistic. Anyhow, I strongly suspect any DeLorean owner, myself included, have...
I do need also refresh the subject. From memory, and with age memory is not what it used to be, there are different recommendations depending if you dig into Volvo or DeLorean manual.
On the warm...
And how is oil pressure now?
I am particularly interested because I’ve lived oil pressure saga of my own. All in all after numerous intervention I have barely 2 bar at 1000 RPM and 4bar above 2000...
Any new developments?
Yesterday I was replacing rubber grommet around fuel pump. While doing that one cannot not to think about fire hazard. There is possibile fuel/air mixture and electric wires with pretty high load...
So I have installed Dave unit today, I have also added remote unit. In order to keep wiring original I did order dedicated 9 pin socket from England and because of Brexit delivery instead of three...
Got myself round to make central locking works, got solenoids rewind, now the question for proficient DeLoreaners, door solenoids mountings have fairly large play on the mounting screws, is there art...
Sorry guys, on different note, my other classic vehicle. D-day celebration.
64817
For Europeans it's kind of obvious. For Americans might be little more difficult to figure out.
64803
Actually exactly same thing happens to my car. My understanding is that it shouldn't be. Any idea how to fix it.
Reply to my own question. The culprit has been found when taking engine apart. To cut the story short the main crankshaft covers got mixed up during previous engine assembly. Only when engine was...
Please observe pictures below,
top line on my phone is speed according to GPS,
62701627006269962698
Daytime pictures are with angle drive from certain European supplier, one form the evening...
So it took me a while but I did checked oil pressure with external gauge.
It’s about 1 bar in Roman Catholic terms or 15 PSI in Church of England units. On idle. With 2000 RPM it’s about 35-40...
this O-ring would be number 19 here?
Getting back there would be taking whole engine apart again, not a job for fainthearted,
62138
Thanks Ron,
I did transfer the old pump to new block. Can't remember about the spring but then again replacement was caused by block crack or rather hole, there was nothing wrong with the pump to...
The oil is same brand, same viscosity as before incident. No matter if it’s new or old sender the measurement is same. The problem has to be within bowels of the engine.
Before I commit myself...
So for almost a year I am trying to bring long term sleeper car to life. One of many but by far biggest problem was corroded engine block. I managed to get other block and do the swap. The car has...