FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com

Search:

Type: Posts; User: RobotMartian

Search: Search took 0.00 seconds.

  1. [Fuel] Oh, I would never intentionally run the engine...

    Oh, I would never intentionally run the engine with a fuel leak. I should have clarified that I'm jumping the RPM relay and doing the Mason jar test. It's the line from the top of the filter so I...
  2. [Fuel] Thanks for all of the help so far. As an update,...

    Thanks for all of the help so far. As an update, and to answer some of the questions asked, the swapped distributor has identical numbers to the one I removed, and the injectors are new numbers...
  3. [Fuel] I appreciate the analogy, that makes a lot of...

    I appreciate the analogy, that makes a lot of sense. I went ahead and replaced the full set of injectors and swapped out a functional distributor. I also put in another fresh fuel filter just to be...
  4. [Fuel] That makes sense, thank you. I'll call John. I...

    That makes sense, thank you. I'll call John. I wasn't sure how wide the pressure difference would be. I should clarify that when I cleaned the tank there was almost no contamination or dirt in it....
  5. [Fuel] Fuel delivery issue - Only new injectors not firing

    I'm trying to hunt down a not firing on all cylinders issue. When I removed the injectors to run a mason jar/spray pattern test I found that 3 had good pattern, 2 were weak, and 1 (cylinder 5) had...
  6. [Engine] Thank you for the leads and solution. I verified...

    Thank you for the leads and solution. I verified the vacuum lines, check valve, and thermal switch routing (cheap snake cams are wonderful). Turns out the system was set way to lean (thanks for the...
  7. Thread: Idle ECU

    by RobotMartian
    Replies
    6
    Views
    738

    [Electrical] I had this very issue for years. Just lived with...

    I had this very issue for years. Just lived with it waiting for it to warm up. Disconnecting the idle ECU did the same as yours. After a VoD job and replacing a handful of wear items (plugs, spark...
  8. Replies
    12
    Views
    2,032

    [For Sale] I'll take number 37, if it is still available.

    I'll take number 37, if it is still available.
  9. Replies
    22
    Views
    4,337

    [Electrical] The Gowesty unit I installed works very well. It...

    The Gowesty unit I installed works very well. It is worth noting that I had to separate the green plastic collar from the metal socket to install it in the DeLorean. I don't believe this has to be...
  10. [Engine] Cold Start and Possible Fuel Pressure Trouble

    Iíve run into a strange cold start issue, and a forum search hasnít turned up anything. When cold the vehicle refuses to start and initially has a pretty strong fuel odor. After cranking for a bit...
  11. Replies
    5
    Views
    602

    [Electrical] When you were doing the upgrade to LEDs, did you...

    When you were doing the upgrade to LEDs, did you replace the flasher relay that is behind the steering wheel?
  12. Replies
    10
    Views
    1,866

    [Frame & Body] Thank you for the advice, guys. It is garage...

    Thank you for the advice, guys. It is garage kept, so that is a plus. I understand that products like POR-15 and Rust-Oleum essentially create a hard film/coat to prevent oxygen access. Does...
  13. Replies
    10
    Views
    1,866

    [Frame & Body] Hidden Rust Inside Frame Tube

    I was replacing the fuel pump and decided to go ahead and drop the fuel tank and do some general cleanup/frame rust/epoxy touch ups. While I was sanding in the tank area, I noticed some slight epoxy...
Results 1 to 13 of 13