Search:

Type: Posts; User: dn010

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    11
    Views
    2,042

    I didn't know you were supposed to remove the...

    I didn't know you were supposed to remove the panel to replace these... :dunno:

    I replaced mine many years ago and used stainless sheet screws as well. Removing the rivets out leaves a of it...
  2. Replies
    9
    Views
    1,118

    [For Sale] SOLD: Piston/liner sets 1X Intake manifold...

    SOLD:

    Piston/liner sets
    1X Intake manifold
    1X fuel rail
    All wiring/ECUs.
  3. Replies
    18
    Views
    546

    [Fuel] It's the material of the original hose that is...

    It's the material of the original hose that is terrible. If you have the soft rubber original hose then do yourself a favor and get it out. I've been running the hardened version (I think it was one...
  4. Replies
    18
    Views
    546

    [Fuel] I've been running OE style "Hayg orig" 909 fuel...

    I've been running OE style "Hayg orig" 909 fuel pumps in my D ($50 on eBay). I replaced the first operational one with a new one because I used the first to get a Volvo running and was afraid I had...
  5. Replies
    6
    Views
    256

    If you don't have an acetylene torch or even a...

    If you don't have an acetylene torch or even a turbo torch, run the engine to get things hot and then try to remove the sensor. Obvious warnings - wear gloves, don't touch the hot pipes, etc.
  6. Replies
    25
    Views
    1,441

    [Suspension] Finally had a minute to revisit this. The...

    Finally had a minute to revisit this. The measurements Ron gave me (Thank you again!) checked out - frame is where it should be along with the bar. I did receive a PM advising me to install a washer...
  7. Thread: A/C not working

    by dn010
    Replies
    4
    Views
    206

    [Heat & A/C] The rheostat controls the brightness of the...

    The rheostat controls the brightness of the lights on the instrument panel, it's the temp selector / thermostat you're turning for the heat/cold.

    Defrost doesn't make use the AC on the DeLorean...
  8. [General] Yes, please do not take offense from my post, Iím...

    Yes, please do not take offense from my post, Iím only showing you that you might want to have some kind of warning statement and a way to have feedback so people can feel more confident when buying.
  9. Replies
    4
    Views
    160

    [General] You don't need "LED" tail light boards, you can...

    You don't need "LED" tail light boards, you can use stock if you beef them up or older updated boards and then get LED bulbs. I purchased the bulbs off amazon and saved a good deal of $. Fuel pump...
  10. [General] Not only that, parts for sale here you can see...

    Not only that, parts for sale here you can see who they're from and how active they are which at least for me gives me piece of mind that I likely will not get burned, and to this day haven't and...
  11. Thread: Window Switch

    by dn010
    Replies
    15
    Views
    679

    [Wanted] No response from Steve so still looking, add a...

    No response from Steve so still looking, add a defrost switch to my list since mine seems to be inop!
  12. Replies
    9
    Views
    1,118

    [For Sale] Bump! Send offers for any of this stuff. The...

    Bump! Send offers for any of this stuff. The pistons/liners are currently in my way!
  13. [Heat & A/C] I was not able to find a way to remove only the...

    I was not able to find a way to remove only the bottom half. I was able to remove the half that contains the evaporator without removing the half that contains the heater core. The bottom of this...
  14. Replies
    55
    Views
    1,953

    [Engine] 7 is about right if my memory is fine. Possibly...

    7 is about right if my memory is fine. Possibly even 8?
  15. Replies
    55
    Views
    1,953

    [Engine] So 14 qts total...?

    So 14 qts total...?
  16. Replies
    55
    Views
    1,953

    [Engine] this lovely sound

    This engine takes a lot of oil. How much did you put in to begin with? If itís reading on the stick and you put in 7 qts, good luck with that!
  17. Thread: Shifting Issue

    by dn010
    Replies
    10
    Views
    296

    [General] [QUOTE=DMC VIN 6639;234869] I'd be putting the...

    I'd be putting the original clutch master/slave back in. I agree it sounds like the clutch isn't disengaging for whatever reason. Maybe the aftermarket hydraulics bent the fork after hitting the bell...
  18. Replies
    55
    Views
    1,953

    [Engine] Lower miles or not, with an engine that's stood...

    Lower miles or not, with an engine that's stood it's possible a valve is stuck open. While I would try a different approach (and along with Ron I also would not touch motor flush until last resort),...
  19. Replies
    55
    Views
    1,953

    [Engine] I wouldnít keep driving it in hopes that the...

    I wouldnít keep driving it in hopes that the noise will just go away. Depending on what it is, simply parking it and investigating the noise will save you hundreds or even thousands of dollars in...
  20. Replies
    55
    Views
    1,953

    [Engine] Pull the valve covers and turn it by hand, see if...

    Pull the valve covers and turn it by hand, see if any valves are stuck.
  21. Replies
    23
    Views
    1,732

    [Electrical] Thanks for the link. I was about to click buy it...

    Thanks for the link. I was about to click buy it now, until...

    I recalled have two Volvo 780 Bertone alternators. Didn't have a clue if it would fit or not but after a forum search it seemed there...
  22. Replies
    12
    Views
    712

    I'm using Rob Grady's hoses, simple to run up the...

    I'm using Rob Grady's hoses, simple to run up the frame and easy to install, nothing to crimp.
  23. Replies
    23
    Views
    1,732

    [Electrical] I decided to revisit this yesterday after getting...

    I decided to revisit this yesterday after getting frustrated with voltage drops to 10 at idle even if it's just trying to power only the vent air motor on 1. I removed my air filter and filter shield...
  24. Thread: WTB Rear fascia

    by dn010
    Replies
    3
    Views
    330

    [Wanted] Are you looking for one due to your current...

    Are you looking for one due to your current fascia sagging in the middle or is it due to damage / missing? I ask because mine was sagging and I was able to straighten it out between heat and putting...
  25. Replies
    5
    Views
    201

    [Engine] He is asking what size it is so he can chase the...

    He is asking what size it is so he can chase the threads.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4