Search:

That's heart breaking. I own several hot rods, some quite fast (quarter mile) and visually impressive, but the DeLorean is by far the most fun car I own to drive. Not because it's a technological...

Not me selling, found it on craigslist, believe it or not. $140 bucks. I've actually seen it. A couple of minor dings, but perfectly usable. I bought a DeLorean front fascia from this guy (Jim), and...

A bar from DMC (delorean.com). $910 plus shipping, which is the actual postage - pretty cheap. At least they don't rape you on the shipping too. I guess they've already been "satisfied". I wish there...

59570

I very carefully measured and placed the bar exactly in line with where it lays end to end in the box. The chisel is about the same width as the hinge and is laid exactly in line with the...

It broke on that end roughly 4-5 inches from the splines, but it broke under the stainless. You couldn't see the break holding the door up. So it didn't break AT the hinge, but near it. Wound up...

59556

While I have absolutely no doubt that a scratch could, and probably will create a stress riser that will eventually cause a failure, close inspection of the actual break of the failed...

Freakin' awesome. If I thought that transaxle would actually handle it reliably, I'd do it in a minute.

I know that there have been people who've modified the factory DeLorean intake for carburetion. Does anyone know where I might find pictures of what exactly they did to the manifold? Just checking to...

Mine had been sitting for 15 years and was, of course, clogged and jammed up completely. After replacing everything in the fuel tank, I rebuilt my fuel distributor as well as my WUR, and it runs...

Ok, tomorrow took a few days to get here. ;-)

The stock muffler is about an inch from the lower pulley and belt. That muffler gets seriously hot seriously fast. Is the factory heat shield betweent the muffler and the pully/belt still there? Mine...

Good point. Easy enough. I drove a 71 Nova street/strip car (way more strip than street) as a daily driver for at least a decade. The front sub frame on that car was about 4 inches off the ground....

That looks great!
That's about where I'm going with mine. I'm dropping the front 1.5", and wasn't even bothering with the rear. The rear might look a tad better maybe a half an inch lower, but it...

Very nice! Once I get it back on the ground and check it, I know how to correct it should it be off. Thank you!

I did. Seemed obvious enough from looking at the geometry that the toe-in would need adjustment. I actually have an alignment rack at my disposal and know how to use it, so no cost involved just 30...

Am I missing something obvious, or is there really no way to adjust the caster or camber on the DeLorean's front suspension? I'm in the process of installing lowering springs (drivers side done,...

It distresses me every time I see paint over all of that beautiful stainless steel. To me it's like spray painting over a Michael Angelo original. The only reason I could ever see as justification...

Docbrwn

That's what I chose in GA. Great minds and all...

I don't know if it was a mistake or what, but in Middle GA they only charged me $18 to transfer the title. With a custom tag it was only $168 total, thank goodness. After following this thread I was...

Brown and round... I can see that.

Great insight guys, Thank You!

3880 is a black interior 5 speed and resides in Hawkinsville GA. It's actually been in Hawkinsville GA since it was purchased new in SC. I recently bought it from the original owner. Will send pic of...

He also gave me this in 36x24. Obviously not a factory or dealership thing, but funny... sort of. He was known to be a bit of a wild one in his younger days, LOL.

LOL. Yes Michael, the internet has ruined most of us.