FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com

Search:

Type: Posts; User: villevol666

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    1,316

    [General] Thanks all. After plugging everything back in...

    Thanks all.

    After plugging everything back in today, the car is running again. I am assuming it was either a problem with the RPM relay or the Fuel Pump. I think I am going to replace both for...
  2. Replies
    3
    Views
    1,316

    [General] Non-Starter

    Hello again.

    I've got a new problem. :(

    When leaving work today, I pulled out of the garage, stopped to check my phone for traffic, and after a few seconds, the car died.

    I managed to start...
  3. Replies
    21
    Views
    6,350

    [Engine] Thanks everyone. After reading the manual, I went...

    Thanks everyone. After reading the manual, I went through the entire system. The ECU and all of the wiring is fine. Turns out the problem was the spring around the throttle control. It has seen...
  4. Replies
    21
    Views
    6,350

    [Engine] I just found this posted in another thread: ...

    I just found this posted in another thread:

    "If you disconnect the entire connector on the passenger side of the idle ECU behind the driver's seat, it will keep the idle right at 2,000 RPM. When...
  5. Replies
    21
    Views
    6,350

    [Engine] Idle sporadically jumps to 2000 RPMs

    Hi All,

    I am having an issue where my idle will randomly jump to 2000 RPMs. It will do so for a few seconds, or for 30 minutes. The problem subsides if I unplug the frequency valve. I haven't...
  6. Replies
    22
    Views
    4,818

    [Engine] The old thermostat was a corroded mess, I can't...

    The old thermostat was a corroded mess, I can't believe it was working at all.
  7. Replies
    22
    Views
    4,818

    [Engine] Thanks for everyone's help, it was the thermostat.

    Thanks for everyone's help, it was the thermostat.
  8. Replies
    22
    Views
    4,818

    [Engine] Yes, temp gauge is working again. Coolant in pipe...

    Yes, temp gauge is working again. Coolant in pipe from radiator never heats up, I'm going to swap the thermostat now.
  9. Replies
    22
    Views
    4,818

    [Engine] Fan is not turning on. Coolant pipe from the...

    Fan is not turning on. Coolant pipe from the front of the car, i.e pipe with the otterstat is cool too the touch...

    Water pump?

    Edit: antifreeze in overflow tank also cold.
  10. Replies
    22
    Views
    4,818

    [Engine] Which bulk head is it specifically? Edit:...

    Which bulk head is it specifically?

    Edit: nevermind, I cleaned them all with wd40 and a wire brush, I'm back in business.

    Checking to see if the fans turn on
  11. Replies
    22
    Views
    4,818

    [Engine] Not sure I have anything in place of the blue...

    Not sure I have anything in place of the blue fail module. Having said that, if the fans work, the otterstat works, the relay works and the fans come on when I jump the otterstat, how could it be fan...
  12. Replies
    22
    Views
    4,818

    [Engine] Fans are new. Replaced 5 months ago.

    Fans are new. Replaced 5 months ago.
  13. Replies
    22
    Views
    4,818

    [Engine] Last mile was still on the freeway....

    Last mile was still on the freeway. Unfortunately, I'm not sure if the temperature because the gauge stopped working 2 weeks ago.
  14. Replies
    22
    Views
    4,818

    [Engine] Bad Thermostat?

    So I was driving home yesterday from my grandparents house, about an hour drive, and in the last mile or so, my heater stopped blowing hot air and when I parked, there was steam spewing from the...
  15. Replies
    9
    Views
    8,415

    [Engine] Thank you all for your help. I ended up...

    Thank you all for your help.

    I ended up cleaning the injectors and replacing the following items:
    Frequency Valve
    Fuel Lines
    Fuel Filter
    Distributor
    Rotor
    Coil
    Plugs
  16. Replies
    9
    Views
    8,415

    [Engine] I pulled the injectors to test the spray...

    I pulled the injectors to test the spray patterns. Only one of them was properly spaying, 2 not spaying at all, the other 3 were severely under performing.

    Would the car running lean for an...
  17. Replies
    9
    Views
    8,415

    [Engine] No, I can take a look at it tomorrow. Any tips?

    No, I can take a look at it tomorrow. Any tips?
  18. Replies
    9
    Views
    8,415

    [Engine] Thanks for the suggestions! I have additional...

    Thanks for the suggestions! I have additional data as of last night that could be beneficial.

    On the way home last night, less than a mile from home, the car died while I was driving it. When I...
  19. Replies
    9
    Views
    8,415

    [Engine] Misfire at Full Throttle

    Hello,

    I am a first time poster but a longtime lurker! :P

    I have been having issues with a strange misfire for the last 6 months or so.

    The car:
    11009 :)
    Starts/Idles perfectly regardless...
Results 1 to 19 of 19