FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com

Search:

Type: Posts; User: Bitsyncmaster

Page 1 of 20 1 2 3 4

Search: Search took 0.40 seconds.

  1. Replies
    13
    Views
    787

    [General] This is just to reduce some heat generated in the...

    This is just to reduce some heat generated in the relay compartment. The OEM relays don't fail much.
  2. Blue/black to Black is correct. The hot start...

    Blue/black to Black is correct. The hot start relay grounds that blue/black when engine is cranking.
  3. Replies
    13
    Views
    787

    [General] I got my 60 amp supply repaired and just ran the...

    I got my 60 amp supply repaired and just ran the resistance check at 40 amps just to verify my old 5 amp check was correct. This also gives me more resolution.

    My AUX relay resulted in 0.4935...
  4. Replies
    13
    Views
    787

    [General] Just for your info. I'm measuring the conduction...

    Just for your info. I'm measuring the conduction resistance so you can calculate the heating produced by any load current. I pump 5 amps through the load and measure the voltage drop in millivolts...
  5. Replies
    13
    Views
    787

    [General] I tried to 3D print a box for the relays and had...

    I tried to 3D print a box for the relays and had no decent results. One thing is I would need to make the circuits a little smaller so the box can take up room to fit in 1.1" outside square. It...
  6. Replies
    13
    Views
    787

    [General] Here are the two AUX relays installed. I mounted...

    Here are the two AUX relays installed. I mounted them further under the metal shelf to keep the wires out of way. Wish I could mount the RPM relay deeper but that has the mount fixed.

    The stock...
  7. Replies
    13
    Views
    787

    [General] The headlight and blower relays are 4 pin...

    The headlight and blower relays are 4 pin normally open "contacts" The difference is one drives the load to pin 30 and the other drives the load to pin to the opposite pin. They are all rated the...
  8. Replies
    13
    Views
    787

    [General] It takes 2 to 3 hours of labor for my potted...

    It takes 2 to 3 hours of labor for my potted items each. I build 10 at a time. I really get sick of potting so I break away with something new to keep my interest. Anyway to pay someone to help at...
  9. Replies
    13
    Views
    787

    [General] Solid state AUX relay

    I've been running my headlight relay to replace the OEM AUX relays in the D. Those have been working fine but I had just glued the relay onto an aluminum angle to mount them and installed a standard...
  10. Replies
    3
    Views
    217

    [Fuel] Sounds like your meter is reading backwards. So...

    Sounds like your meter is reading backwards. So you may have to readjust the normal dwell.

    You should read 45 deg. dwell on a cold start but that would read the same forward or backward.

    WOT...
  11. [Brakes] The bearings pull apart because the inner race...

    The bearings pull apart because the inner race gets stuck on the hub. I bet yours just pulls off easy.
  12. [Fuel] I would check the control pressures with the new...

    I would check the control pressures with the new WUR. If that is good the only thing left is the fuel distributor.
  13. [General] Most common problem with a new to you car is...

    Most common problem with a new to you car is mixture is not set correctly. That can cause starting and running issues. I would suggest you get a dwell meter and check and set the mixture before...
  14. [Engine] Would not think so. But with the AC on your...

    Would not think so. But with the AC on your cooling fans are running which are a high current draw. Just do a voltage test at the fuel pump with the AC on to test that condition.
  15. Replies
    17
    Views
    891

    [Fuel] That is normal for those crushed brass filters. ...

    That is normal for those crushed brass filters. I would check your control pressure without the filter installed. My guess is your WUR is bad if the control pressure is the same as your primary...
  16. [Engine] My guess to engine dying would be bad fuel pump. ...

    My guess to engine dying would be bad fuel pump. I say that because not much else in the fuel system could cause the stated results you get. I don't think it's ignition related.
  17. Replies
    18
    Views
    2,900

    [Fuel] The LED turning on indicates the idle motor is...

    The LED turning on indicates the idle motor is fully closed so it can't reduce idle any more. With the LED off it indicates the idle motor still has range to control idle speed. If it is still off...
  18. Replies
    12
    Views
    661

    [Electrical] From memory, the RPM relay and a few other relays...

    From memory, the RPM relay and a few other relays in the back row share a ground wire running back to that ground post. So not many have found that daisy change to act up. I did have one customer...
  19. Replies
    12
    Views
    598

    [Engine] I think because of the constant loads in new...

    I think because of the constant loads in new cars, all manufactures have increased the typical alternator voltage to 14.5 volts to get the batteries charged faster.
  20. Replies
    20
    Views
    867

    [General] Idle motor is an electrical valve that is driven...

    Idle motor is an electrical valve that is driven by the idle ECU which opens and closes to maintain a fixed idle RPM. It's mounted on the drivers side valve cover and has a 3 pin electrical...
  21. Replies
    20
    Views
    867

    [General] Electronics that use a switching circuit can...

    Electronics that use a switching circuit can cause an audio noise if driving a magnetic load (transformer, etc). The Lambda drives the FV and the idle ECU drives the idle motor which we know make...
  22. Replies
    12
    Views
    598

    [Engine] Your battery is bad or not charged if it drops to...

    Your battery is bad or not charged if it drops to 8 volts when cranking. First thing is to charge or replace the battery.
  23. Replies
    19
    Views
    689

    [Engine] If you jump the double yellow/red wires to the...

    If you jump the double yellow/red wires to the brown wire on the RPM relay connector you will power the Lambda system without the engine running. Then it is easy to hear the FV buzz. I do that if I...
  24. Replies
    8
    Views
    503

    [General] I've never really thought to check my play. So...

    I've never really thought to check my play. So just checked it with it sitting in the garage. Using very light force it seems to be less than 1/8". I have stock steering.
  25. [Heat & A/C] Most common leaks are the service valves but...

    Most common leaks are the service valves but never hear of those causing that fast of leak. To test just put your finger over them after charging. You will feel and hear pressure if they are...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4