Search:

Type: Posts; User: DMC5180

Page 1 of 20 1 2 3 4

Search: Search took 0.07 seconds.

  1. Replies
    349
    Views
    84,089

    How much further does the wheel / tire stick out...

    How much further does the wheel / tire stick out of the wheel opening? How close is the tire to contacting the front of the wheel opening when the tires are turned inward with a load in the trunk?...
  2. Thread: A/C blues

    by DMC5180
    Replies
    33
    Views
    1,240

    [Heat & A/C] Not necessarily. lt's an o-ring compression seal....

    Not necessarily. lt's an o-ring compression seal. the Evap Tube is Aluminum it may have deformed the Bubble flange slightly that the nut pushes on . Since you can't budge the nut at the movement,...
  3. Replies
    6,650
    Views
    811,723

    [General] What have you done to your DeLorean today?

    it sits just to the left of the Ballast resistor. You have an Early VIN, but you should have one.

    It's purpose is provide Full battery voltage to the coil while cranking only, then the Ballast...
  4. Replies
    60
    Views
    3,998

    [General] Electronic Otterstat

    You need one of those portable Inductive "hot plate" cookers "as seen on tv" product. you can set and hold the temp just like an oven.

    Unfortunately the units are about $100 at Walmart.


    Sent...
  5. Thread: A/C blues

    by DMC5180
    Replies
    33
    Views
    1,240

    [Heat & A/C] That is a bugger of connection to get wrenches...

    That is a bugger of connection to get wrenches on. The Evaporator nut is steel Female thread. I don't no how you are cutting the Accumulator Nut, but you must not damage the Evaporator Nut or tube....
  6. Replies
    60
    Views
    3,998

    [General] Which reading represents the middle White line? ...

    Which reading represents the middle White line?


    Sent from my iPhone using Tapatalk
  7. Replies
    60
    Views
    3,998

    [General] Do you have a small deep fryer? Cooking oil...

    Do you have a small deep fryer? Cooking oil boils at about 300 C.


    Sent from my iPhone using Tapatalk
  8. Replies
    1,624
    Views
    251,351

    My experience with gas station comments or...

    My experience with gas station comments or questions depends on whether I'm alone or not.

    When traveling with my wife. Gas station chatter is usually much less. More often than not the typical...
  9. Replies
    5
    Views
    412

    [Frame & Body] I also installed the DeloreaGo seals right before...

    I also installed the DeloreaGo seals right before the DMCMW open house. no more seal drag and I did not notice any abnormal air noises while driving at interstate speeds.


    Sent from my iPhone...
  10. Replies
    10
    Views
    563

    The terminals are in the fusebox . Just no fuses...

    The terminals are in the fusebox . Just no fuses in those locations.

    visible fuses missing

    #3 10 amp windshield wiper/ washer fluid pump

    #9 10 amp heated rear window/ power mirrors

    #10...
  11. Replies
    60
    Views
    3,702

    [General] The kicker reshaping the nose is that you have to...

    The kicker reshaping the nose is that you have to maintain the lines of the exiting fenders.

    The rubber nose on the Daytona's and Super bird's was A factory Add-on that they were able to shape to...
  12. Replies
    28
    Views
    1,051

    [Fuel] just looking for things out of normal. I see an...

    just looking for things out of normal. I see an extra Ground wire (middle) in the cluster on the Intake manifold next to the ISM. track down where it goes to make sure it's a legitmate ground and not...
  13. Replies
    28
    Views
    1,051

    [Fuel] HELP: D won't start without starter fluid

    the FV only runs when the engine is running.


    Sent from my iPhone using Tapatalk
  14. Replies
    28
    Views
    1,051

    [Fuel] HELP: D won't start without starter fluid

    jumper the Rpm relay to run the fuel pump. You don't need the engine running. however if it is a stuck plunger situation, you will want to pull All the injectors and place them in jars first, so you...
  15. Replies
    6,650
    Views
    811,723

    [General] Good catch. DM NOS from factory inventory...

    Good catch. DM

    NOS from factory inventory most likely.


    Sent from my iPhone using Tapatalk
  16. Replies
    231
    Views
    23,833

    3.0L engine swap

    If the gauge is pegged straight up, you have an open circuit. It's not necessarily the sending unit itself. I could be oxidization at the cluster PCB or any connection between the sender and Gauge....
  17. Replies
    60
    Views
    3,702

    [General] I recall seeing that engine too, when I went to...

    I recall seeing that engine too, when I went to the Last Kapac Open house Event before Stephen acquired the total inventory.

    I wonder if the engine is now sitting on a Crowded pallet rack at DMCH...
  18. Replies
    294
    Views
    31,497

    4877 Ressurecting a bad girl...

    It has been several years since I looked at these. My memory did not recall the Side to side position. But from the looks of things your pump boot is 180 opposite of mine.
    ...
  19. Replies
    294
    Views
    31,497

    I'll post a photo of my fuel pump tomorrow. I...

    I'll post a photo of my fuel pump tomorrow. I still have the Orange hoses too.


    Sent from my iPhone using Tapatalk
  20. Replies
    294
    Views
    31,497

    Strange, did you lift the clamp and run your...

    Strange, did you lift the clamp and run your fingers all the way around it? The return line port through the boot should be rotated to about the 12 O clock position. the pressure line barb should be...
  21. Replies
    294
    Views
    31,497

    looks like the lower pump boot is rotated out of...

    looks like the lower pump boot is rotated out of position. The boot has 2 notches for the pump wires to sit in when the cover boot is in place. the notches a typically positioned at the 10-11 O clock...
  22. Replies
    294
    Views
    31,497

    there's really only one natural orientation the...

    there's really only one natural orientation the hoses work. which is from the rear pointing forward.


    Sent from my iPhone using Tapatalk
  23. Replies
    294
    Views
    31,497

    It's one of those that just happens without...

    It's one of those that just happens without warning. Just try not to disturb them to much.


    Sent from my iPhone using Tapatalk
  24. Replies
    294
    Views
    31,497

    4877 Ressurecting a bad girl...

    Your orange hoses are from PJGrady. They have been known to fail ( break ) where the hose is pushed onto the fitting barbs. especially the feed line at the hard line connection. About 10 years seems...
  25. Replies
    231
    Views
    23,833

    It's amazing to see how crudely these boards were...

    It's amazing to see how crudely these boards were made. Hand assembled Technology of the day. Compare that with modern day Surface mount assemblies built by high speed robots. The difference is...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4