FRAMING JOHN DELOREAN - AT THEATERS THIS WEEKEND & ON VOD www.framingjohndeloreanfilm.com

Search:

Type: Posts; User: Bitsyncmaster

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    7,844
    Views
    1,207,909

    [General] Replaced the coil and that did not fix it. So...

    Replaced the coil and that did not fix it. So going to order a new cap and rotor.
  2. Replies
    10
    Views
    194

    If money is no object, these servos should have...

    If money is no object, these servos should have plenty of power and they hold without power.
    ...
  3. Replies
    7,844
    Views
    1,207,909

    [General] Agree. Since reducing the high voltage by...

    Agree. Since reducing the high voltage by reducing the gap helped I'm thinking it may be a cross fire. I'm not running a stock coil. I'm running a GM ignition module and a 1.5 ohm coil. I will try...
  4. Replies
    7,844
    Views
    1,207,909

    [General] Well today I checked the fuel pump current at 6.3...

    Well today I checked the fuel pump current at 6.3 amps. engine off so that looks fine. Since I was in the washer bottle area I though maybe a connector for the fuel pump wire got moved.

    I then...
  5. Replies
    7,844
    Views
    1,207,909

    [General] Took the D to the grocery store just now. The...

    Took the D to the grocery store just now. The engine is skipping mostly when the engine is loaded during acceleration. It did it cold and hot so I suspect it's a problem in ignition. I checked the...
  6. Replies
    41
    Views
    1,881

    [Electrical] So are these black plastic strips that go between...

    So are these black plastic strips that go between the lights just to remove the chrome look of the headlight benzyl? I was thinking of painting my benzyls black.
  7. Replies
    41
    Views
    1,881

    [Electrical] Here are some photos of the 4 sided new LEDs on...

    Here are some photos of the 4 sided new LEDs on the driver's side inner light (High beam) and the old 2 sided LED on the passenger side inner light(High beam). As you can see a big difference in the...
  8. Replies
    11
    Views
    265

    [Heat & A/C] I once had a compressor bolt fall out (not on a...

    I once had a compressor bolt fall out (not on a DeLorean). The result was a leak like your seeing. The threads were stripped but it had held many years with no problems. I guess the factory had...
  9. Replies
    9
    Views
    365

    [General] Got the harness wrapped and installed. Can't get...

    Got the harness wrapped and installed. Can't get the grommet where the harness passes through the washer bottle installed. Also left the washer bottle out and will put that and the grommet in when...
  10. Replies
    9
    Views
    365

    [General] Wish I never started the wire replacement. Way...

    Wish I never started the wire replacement. Way to much work for what it improves. With LED headlights there is less voltage drop over the wiring anyway because there is less current draw. But the...
  11. Replies
    10
    Views
    335

    [Fuel] Use a solvent to clean the valve in the idle...

    Use a solvent to clean the valve in the idle motor. Shake or blow out the solvent, let it dry and use a little light oil on the valve. Don't turn the valve with anything metal, use wood so you...
  12. Replies
    10
    Views
    335

    [Fuel] The most common causes of idle hunting are a weak...

    The most common causes of idle hunting are a weak O2 sensor and or a dirty idle motor. But some cars seem to hunt a little no matter what you do. Also the adjustment of the curb idle screw will...
  13. Replies
    1
    Views
    116

    Sorry, forgot the link. ...

    Sorry, forgot the link.

    https://www.sherco-auto.com/striped-tracer-wire.html?Array=&utm_source=&utm_medium=&utm_term=&utm_content=&utm_campaign=
  14. Replies
    9
    Views
    365

    [General] Those look pretty good but the price is quite...

    Those look pretty good but the price is quite high. And it only offers high and low beam where as our cars use a dual high low beam on the outer bulbs.

    My wire should show up today but not sure...
  15. Replies
    1
    Views
    116

    Tracer wire (striped wire)

    I saw this source for tracer wire if you want to buy short lengths. I like to use 300 volt insulation because it's smaller and more flexible but if you don't mind 600 volt this looks like a good...
  16. Replies
    41
    Views
    1,881

    [Electrical] I forgot to mention that the 4 x 6 bulb housing...

    I forgot to mention that the 4 x 6 bulb housing did not heat up at all during my bench test. The rear fan cooled heat sink did heat up quite a bit but not as much as my first LED.

    So I like the...
  17. Replies
    41
    Views
    1,881

    [Electrical] Got the new LEDs today. Bench tested but can't...

    Got the new LEDs today. Bench tested but can't put in the car yet since my harness is apart.

    Note with these and the old LEDs current drops as it heats up so these currents are after running for...
  18. Replies
    389
    Views
    120,041

    The stock idle ECU never closes the idle motor...

    The stock idle ECU never closes the idle motor fully. My bet is your deceleration valve springs are bad.
  19. Replies
    41
    Views
    1,881

    [Electrical] Since I'm waiting on parts (LEDs, wire and...

    Since I'm waiting on parts (LEDs, wire and connectors) I decided to pull the washer bottle so I could pull the front harness. Turns out the low beam has one pin with 16 AWG blue/red wire to feed the...
  20. Replies
    41
    Views
    1,881

    [Electrical] Looks like these felt pads will solve the shorter...

    Looks like these felt pads will solve the shorter mounting on my housings.
  21. Replies
    41
    Views
    1,881

    [Electrical] Thanks Dana for those photos. So I guess I can't...

    Thanks Dana for those photos. So I guess I can't get the brackets out with removing the front bumper.

    By the way the drivers side connector connector has the black 28 strand wire (14 AWG...
  22. Replies
    41
    Views
    1,881

    [Electrical] How do you remove the headlight brackets? I see...

    How do you remove the headlight brackets? I see one nut holding one side near the center which is accessible, is there a nut on the other side which I can't see?
  23. Replies
    41
    Views
    1,881

    [Electrical] It looks like my headlight buckets had a rubber...

    It looks like my headlight buckets had a rubber bumper at the 4 mounting points where the headlight sits. But I only found one remaining but I saw the rest had glue remnants. So I can put some...
  24. Replies
    16
    Views
    1,872

    [Heat & A/C] I recall testing my blower on fan speed 4 at 26...

    I recall testing my blower on fan speed 4 at 26 amps.
  25. Replies
    41
    Views
    1,881

    [Electrical] Much cooler housings due to less current and a...

    Much cooler housings due to less current and a fan. Also the H4 housings have a metal back which would conduct more heat from the "bulb".

    I wonder how much air moves in that closed headlight area.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4