This modification only uses the two 12volt wires that went to the solenoids. No ground needed only polarity reversing.
Type: Posts; User: hjhjr
This modification only uses the two 12volt wires that went to the solenoids. No ground needed only polarity reversing.
In all my Delorean internet browsing, I never ran into this modification. I intended for it to work with actuators only.
No one has replied to my thread. good, bad , indifferent
enlarged schematic diagram 6987069869
69847698486984969850698516985269853698546985569856
The copper crush washer hardened with use They can be made malleable by heating red hot and cooling. They will seat better.
I remembered right after I got the car the doors were lazy got new struts still lazy i proceed to access the roof box adjusted torsion bars. Did notice that box had bowed . I just put some self...
I have owned th car for10years. I guess the roof box is ok. How to tell if there is a problem.
Fixed stick door by applying more closing pressure than I could(see pictures), Door was closing to tight . The locking pin was set to tight which was its looses position. I had to grind backing plate...
Latch would not release when pressing in on door. What next?
Thanks
Hilton Hoover
Passenger door front lock stuck i just finished resetting all linkages and the door was opening fine. I shut the door a little harder the rear latch released. The front latch would not release. I...
White in toward Tee
warm up pressure regulator 30PSI at 66deg, 20 PSI when accelerating when cold. 52PSI after warm up .Primary pressure 75PSI
Having a cold acceleration problem. Acceleration is fine after warm up The pressure regulator pressure is 30PSI at 66deg.drops to about 20PSI upon acceleration. The engine hesitates and black smoke...
I purchased one from Dave Barton Volvo. Installed it works just like the original $8.00 $4 dollars shipping from Texas.
Replacement for Volvo PN 1324749 (Bosch PN 0-332-015-006)
PICKER Black...
the lock link was held to the toward the center of door. The door is still stuck.
Passenger door front latch stuck. removed door panel and latch control. Have full access to all linkages, rear latch is released. I can lock and unlock front latch and door release responds to lock...
Home made Outterstat stainless steel clamp.
6642866429/attach]66430664316643266433
I picked this adapter up Dirt Cheap. I did not know what I was going to do with it. i had to file to outside diameter a little to make it a good fit. ...
Bearings seals do matter. They keep out dust (there is large amount of air being pulled through the alternator with accompanying dust) they also retain the grease in the bearing.
I just checked with a trace light. The warm up regulator ground is the ground pin on the regulator. In other words pin 23 from the regulator grounds the Lambda ECU pin 16 through the regulator.. I...
pin 22or 23 of the blue connector are not connected to ground. where do they connect to ground? I cannot tell by the ground diagram.
No it is a solid black wire.
My WUR ground wire connection is not grounded. The black ground wire has continuity to the blue connector in the ignition coil box. The bulked head connection is not grounded. Does anyone know where...