Search:

Type: Posts; User: Jason

Page 1 of 7 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    28
    Views
    657

    [General] Does anyone have an agreed value policy without...

    Does anyone have an agreed value policy without any driving restrictions, and if so with which insurance company?
  2. Replies
    257
    Views
    46,889

    The parts experience is a lot different from the...

    The parts experience is a lot different from the DeLorean.

    New rear brake cylinders in stock at the local parts store. $13 each.

    Water pump: $40 including free overnight delivery.
  3. Replies
    257
    Views
    46,889

    I just picked up this... 58508 1991 Toyota...

    I just picked up this...
    58508

    1991 Toyota Sera. Right hand drive.
  4. Replies
    7
    Views
    370

    https://www.youtube.com/watch?v=7MzRdz3WP2M&t=102s

    https://www.youtube.com/watch?v=7MzRdz3WP2M&t=102s
  5. Replies
    375
    Views
    86,618

    There should be three bolts for the starter.

    There should be three bolts for the starter.
  6. Replies
    7
    Views
    370

    https://www.instagram.com/p/Bo7YEySAveg/ 58324 ...

    https://www.instagram.com/p/Bo7YEySAveg/
    58324

    I don't know who took the picture, but it's my car in the background.
  7. Replies
    43
    Views
    8,536

    I 3D printed some custom ductwork so that I could...

    I 3D printed some custom ductwork so that I could route the center A/C vents to the sides of the center console to make room for a 2 din head unit while still retaining correct control of the center...
  8. Replies
    12
    Views
    873

    [General] I just put one in my car, and also used a similar...

    I just put one in my car, and also used a similar kit from DMCH on the rest of the center console.

    58153

    58152

    I did the install myself, and had no previous experience doing this sort of...
  9. Replies
    14
    Views
    971

    [General] I "restored" my headliner panels by gently...

    I "restored" my headliner panels by gently scraping them clean and then painting them with fiberglass resin.
  10. [Heat & A/C] How much oil to add when replacing the evaporator?

    If replacing just the AC evaporator and accumulator, and not flushing the system, how much oil should be added before putting back the refrigerant?

    The AC system was evacuated and opened to remove...
  11. Replies
    20
    Views
    1,320

    [Frame & Body] I just recovered my rear panels. I shopped around...

    I just recovered my rear panels. I shopped around locally for someone to do them, but no one wanted to touch them, so I decided to try it myself.

    My panels had a single piece of vinyl covering...
  12. Replies
    4
    Views
    231

    [Heat & A/C] To answer my own question... After struggling...

    To answer my own question...

    After struggling with this for way too long, I put the boot across a reversed woodworking clamp, extended the clamp to stretch out the boot, and let it sit that way...
  13. Replies
    4
    Views
    231

    [Heat & A/C] how to install evaporator/heater core boot?

    Is there any trick to getting the evaporator/heater core boot (part# 105847) pulled back over the retaining ring? I've been struggling with if for a couple of hours now. There doesn't seem to be any...
  14. Replies
    2
    Views
    210

    [Electrical] Thanks!

    Thanks!
  15. Replies
    2
    Views
    210

    [Electrical] Where do these connectors go?

    I'm in the middle of refurbishing the evaporator box and replacing the carpets. Somewhere along the way I must have knocked these two connectors loose, as a don't remember disconnecting them and have...
  16. [Heat & A/C] So I stopped trying to find an easy way out and...

    So I stopped trying to find an easy way out and pulled the evaporator/heater box out as one piece.

    Which now leads to the question, if just replacing the evaporator and accumulator, how much oil...
  17. Replies
    5
    Views
    435

    [Frame & Body] Are you sure? I don't mean the covers over the...

    Are you sure? I don't mean the covers over the fuse/relay and ecu areas. I mean the vertical panels with the cubby hole cutouts that go in front of the battery and storage compartment areas.
  18. Replies
    5
    Views
    435

    [Frame & Body] How to remove wooden rear bulkhead pieces?

    How do you remove the two wooden lower bulkhead pieces, part #s 106193 and 106192?

    I see the two screws at the tops of each piece near the center of the car, but it's not clear what else is...
  19. Thread: Clutch replace

    by Jason
    Replies
    150
    Views
    6,554

    [Transmission 5-Speed] I did my clutch recently, and didn't have to...

    I did my clutch recently, and didn't have to disconnect the parking brake cable. I was able to just push it forward past the front of the transmission. It did mean I had to have one hand pushing on...
  20. Replies
    22
    Views
    1,634

    [Engine] 56983 56984 56985 I have about 30-40k miles...

    56983
    56984
    56985

    I have about 30-40k miles on that setup. I should probably remove the brackets and clean and paint them.
  21. Replies
    22
    Views
    1,634

    [Engine] I had the same issue. Josh offered to replace the...

    I had the same issue. Josh offered to replace the muffler if I sent the old one back, but I at the time I didn't want to have the car off the road for that long, so I ended up modifying my old heat...
  22. [Heat & A/C] The evaporator was installed (not by me) without...

    The evaporator was installed (not by me) without the proper sealing around the edges of the evaporator. I semi fixed it by working through the blower motor hole, but I suddenly felt motivated to try...
  23. [Heat & A/C] Can you remove the bottom half of the evaporator box without removing the evaporator?

    Is it possible to remove the bottom half of the evaporator box without evacuating the AC system and disconnecting the evaporator?

    I'm able to remove all the screws (after removing the glovebox,...
  24. Replies
    17
    Views
    1,157

    [Transmission 5-Speed] I guess you don't remember as its been a long...

    I guess you don't remember as its been a long time, but you did the sleeve and seal. The transmission is the rebuilt one that you installed for me something like 12 years ago, that started leaking...
  25. Replies
    17
    Views
    1,157

    [Transmission 5-Speed] That goop is all gear oil. Despite having the...

    That goop is all gear oil. Despite having the seal replaced and the input shaft sleeved that transmission likes to leak from the input shaft. I've kind of given up on it for now. Other than making...
Results 1 to 25 of 163
Page 1 of 7 1 2 3 4