I've got a driver's side taillight on offer. It's missing the insert. Asking $700 obo.
Type: Posts; User: Dhennick99
I've got a driver's side taillight on offer. It's missing the insert. Asking $700 obo.
I'm running a stock auto and have had issues with idle hunt as well. I'd be curious in updating when Dave is ready.
Interested in the next batch!
Blue led, if you're able.
69261
Match the interior.
Are the mixture values the same with an automatic, or should the dwell be adjusted either more rich or lean?
What are you asking?
I've developed a hole in my muffler and am looking for a replacement. My exhaust is stock and I'm running the two pea shooters, so if anyone has upgraded their exhaust and would like to unload the...
About a week ago the car started slogging along when the AC is turned on. It isn't immediate. If I run the AC for about 10 minutes the car feels like it's dragging a boat anchor. Even if I cut the AC...
No, where are those located? Can you reply with a photo?
I've attached a photo of the wide needle swing I'm getting on the dwell meter. Any ideas as to how I might remedy this?
...
If you find it, let me know.
As far as the frequency valve is concerned, once I reattached the vacuum line and richened the fuel mixture I started to get a reading from the dwell.
I think I may have gotten a handle on it. There was a vacuum leak, one of the lines connected to the T right in front of the idle motor was disconnected. The car was running very lean, once I got...
So I got the frequency valve to buzz and it's working. I was able to set the fuel mixture using a dwell. I have it right in the sweet spot, but the idle is still super high in neutral and park (I...
The o2 sensor was recently replaced in an effort to get a handle on the hunting.
The muffler isn't getting red hot. Richening the mix won't engage the frequency valve? The ground is intact.
Bulkhead connectors were solid. I don't know what else there is to tell as far as backstory. The car just started the spuddering without warning or anything leading up that would be identifiable as...
Car was sputtering bad. Had it floored and it would barely go. I had an aftermarket Bosch idle motor installed previously. So I swapped back in the factory idle motor and it was still doing it. I had...
Once you have a design finalized, I'll be a day one buyer. Your upgrades are the best!
I missed the boat when forum member Steelwings did a run of these. If anyone would be willing to part with theirs, I'd be very interested. PM if you're open to sell.
65093
Shifting smoother? Is the difference noticeable?
I'm going to be upgrading the governor computer for my automatic transmission. I was curious as to those who have performed the update and your experience with it. Pros and cons welcome.
I've got an oil leak that's getting progressively worse. Any ideas where it could be coming from and what measures I can take to fix the issue?
6378763788
63702
I mounted the speedbox right under the lambda counter
It's working nicely now.
The little internal piece of the cable keeps sliding out of the square portion where the cable screws into the speedbox. There's not alot of slack to really feed it in before tightening everything...
I have an aftermarket cruise control. Will it still function with this GPS box? Also which speedo cable do I select when purchasing?
The airflow coming out of the center vents is not consistent between each side. The right vent blows a lot of air and the left vent hardly any. Is this a common issue with the car and if so, is there...
I'm having an issue with the interior lights only coming on when the passenger door is opened. The plungers on the driver's side look good and the door lights illuminate when opened. So I don't know...