FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com

Search:

Type: Posts; User: Ron

Page 1 of 20 1 2 3 4

Search: Search took 0.17 seconds.

  1. Replies
    657
    Views
    188,078

    Duplicate account(s), the last time, IIRC. ...

    Duplicate account(s), the last time, IIRC.
    Nothing related to rip offs here.

    Kind of OT...and you should be asking him. :deviltail:
  2. Replies
    657
    Views
    188,078

    Won't work - Bill has been permabanned from most...

    Won't work - Bill has been permabanned from most D sites last I knew.
    Try Facebook.
  3. Replies
    5
    Views
    197

    [General] $.02 CO should always be set last. You should...

    $.02

    CO should always be set last. You should figure out why it keeps dying and having starting problems first. I would treat it like a new engine and go to square one:
    -Inspect and clean/replace...
  4. Thread: Fuel pressure

    by Ron
    Replies
    15
    Views
    518

    [Fuel] I'd try powering the pump right off of a fully...

    I'd try powering the pump right off of a fully charged battery. And if the pressure, measured right at the pump, was still low, pull it. And if the pump intake was not restricted, I'd replace it.
  5. [Engine] Yes. It starting instantly indicates the...

    Yes.

    It starting instantly indicates the charging system-battery is probably OK.

    Sounds like cylinder(s) not firing/missing. You might try pulling plug wires one at a time while it is idling...
  6. Replies
    8,806
    Views
    1,924,028

    [General] Gotta' watch those sharp right turns!

    Gotta' watch those sharp right turns!
  7. [Engine] The leak and belt sounds like they unrelated to...

    The leak and belt sounds like they unrelated to the other problems.
    I agree WRT alignment and would check it closely before fixing the leak/pump.

    Does it start right up after it dies...without a...
  8. Thread: Lamda not working

    by Ron
    Replies
    18
    Views
    2,738

    [Fuel] Didn't re-read it all, so stabs in the dark:...

    Didn't re-read it all, so stabs in the dark:
    Ensure the three brass screws are shut.

    Perform all of the procedures (record, and post if off) at D:04:15/5.

    Record where the CO screw is...
  9. Thread: Hanging high idle

    by Ron
    Replies
    19
    Views
    516

    [Engine] IIRC, you can pull the FD and look down into the...

    IIRC, you can pull the FD and look down into the hole...you'll see what's going on.

    Be careful not to let the plunger fall out of the FD and hit anything...
  10. Replies
    10
    Views
    444

    [Engine] ..and the young man on the orange tractor wins by...

    ..and the young man on the orange tractor wins by a nose!
  11. Thread: Hanging high idle

    by Ron
    Replies
    19
    Views
    516

    [Engine] Just reread everything and have a few thoughts......

    Just reread everything and have a few thoughts...

    Pressing/pumping the throttle doesn't "give it gas to start" (no spray pump like a carb has).

    It cold, running rich with good idle, then high...
  12. Replies
    12
    Views
    484

    [Electrical] Sorry, no...It's the same in the Resources...

    Sorry, no...It's the same in the Resources section here. But you might try clicking the image to enlarge it, then again to enlarge again, then save it.
  13. Replies
    12
    Views
    484

    [Electrical] Best info I have, courtesy of post by Bill...

    Best info I have, courtesy of post by Bill Robertson. (See red square below.)
    67140
  14. Thread: Fuel pressure

    by Ron
    Replies
    15
    Views
    518

    [Fuel] ^^^ +1!

    ^^^
    +1!
  15. Thread: Car chugging

    by Ron
    Replies
    12
    Views
    413

    [Engine] Yeah, they have kept raising it over the years....

    Yeah, they have kept raising it over the years. The replacement regulators for rebuilders were mostly 14.2V regulators for decades (esp. GM)...we bought them by the 100s. But now, the ECU is in...
  16. Thread: Sound dyinosis

    by Ron
    Replies
    20
    Views
    629

    [General] Since it is RPM related, you might try switching...

    Since it is RPM related, you might try switching the engine off and and see what you hear while it is coasting.

    Also, you've made at least two OT political comments in this thread so far -- Three...
  17. Thread: Car chugging

    by Ron
    Replies
    12
    Views
    413

    [Engine] Specs on a stock alternators call for >13.5V. The...

    Specs on a stock alternators call for >13.5V. The regulators in most replacement alternators (modern) will settle at ~14.2V no matter how much the alternator "pushes"....just a matter of time.
  18. Thread: Sound dyinosis

    by Ron
    Replies
    20
    Views
    629

    [General] :yesss:

    :yesss:
  19. Thread: Sound dyinosis

    by Ron
    Replies
    20
    Views
    629

    [General] My guess is a loose screw.

    My guess is a loose screw.
  20. Thread: Car chugging

    by Ron
    Replies
    12
    Views
    413

    [Engine] Sounds like it could be the alternator (or...

    Sounds like it could be the alternator (or battery). But 40 minutes seems to be a little long unless you didn't use the lights, AC etc. Most auto parts stores will check them on the car for free. But...
  21. Thread: Hanging high idle

    by Ron
    Replies
    19
    Views
    516

    [Engine] I'm voting for the deceleration valve springs....

    I'm voting for the deceleration valve springs....
  22. Thread: Fuel pressure

    by Ron
    Replies
    15
    Views
    518

    [Fuel] Something seems wrong here -- The pressure at the...

    Something seems wrong here -- The pressure at the FD should match the pump pressure. (The accumulator, filter, and lines might restrict flow, but not pressure to the FD).

    Also, with 4.5 Bar at...
  23. Thank you for kindly confirming my suspicion(s).

    Thank you for kindly confirming my suspicion(s).
  24. Replies
    8
    Views
    1,801

    [Wanted] Since it's been years since the OP posted in this...

    Since it's been years since the OP posted in this thread and it looks like he had his fixed, I didn't want to close it if he is still looking.

    FWIW- You'll have better luck posting your own ad and...
  25. Replies
    8
    Views
    1,801

    [Wanted] Are you still looking for a "good one"?

    Are you still looking for a "good one"?
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4