FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com

Search:

Type: Posts; User: Jimmycxc

Page 1 of 7 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    49
    Views
    13,648

    [General] Apparently, mine was never changed out after all...

    Apparently, mine was never changed out after all these years. I have no white splotch. It is located on the footwell though.
  2. Replies
    49
    Views
    13,648

    [General] After all this, it's the inertia switch. ...

    After all this, it's the inertia switch. Bypassed temporarily and car ran great for 45 minutes before I turned the key off. Ordered a new one and should be here by Tuesday. Thank you all again for...
  3. Replies
    49
    Views
    13,648

    [General] Was thinking it could be as simple as a plugged...

    Was thinking it could be as simple as a plugged filter. Can't hurt to replace it. I did take the pump out and checked it the suction hose was collapsed, but it was good.
  4. Replies
    49
    Views
    13,648

    [General] I would not call it consistent. ill have to time...

    I would not call it consistent. ill have to time if a few times to really see. I took off the air filter and watched the air flow sensor plate during idle. Right before it dies, the plate moves...
  5. Replies
    49
    Views
    13,648

    [General] Update: Received my new relays and put them...

    Update:

    Received my new relays and put them in. Fuel pump will not turn on now. Tried jumping it and nothing. I removed the new Lambda relay and plugged the old one back in. Fuel pump turns on...
  6. Replies
    49
    Views
    13,648

    [General] Just ordered a new set of relays just for shits...

    Just ordered a new set of relays just for shits and giggles.
  7. Replies
    49
    Views
    13,648

    [General] Not sure what happened, but when I tested...

    Not sure what happened, but when I tested everything again before I spliced in a new wire and now each wire is either zero or 0.4 ohms.
  8. Replies
    49
    Views
    13,648

    [General] Got 4 ohms resistance one the first wire. 0.3...

    Got 4 ohms resistance one the first wire. 0.3 Olmsted second wire, and no continuity for the third. Looks like I need to run a new wire.
  9. Replies
    49
    Views
    13,648

    [General] Gotcha. Thanks Dave

    Gotcha. Thanks Dave
  10. Replies
    49
    Views
    13,648

    [General] Still troubleshooting and discovered this...Took...

    Still troubleshooting and discovered this...Took the air filter box off and with the car running at idle, I push down on the plate and it immediately stalls.
  11. Replies
    49
    Views
    13,648

    [General] A little update. The car starts up great on a...

    A little update. The car starts up great on a cold start. It idles, although it does hunt a little bit (always done this). I can rev up the engine and it goes back to idling.

    So I decided to...
  12. Replies
    49
    Views
    13,648

    [General] Thanks. I would definitely need some pics to...

    Thanks. I would definitely need some pics to fully understand what you did. I can splice in new wires, but not sure where everything is located.

    Also, with my issue, it doesn't always start right...
  13. Replies
    49
    Views
    13,648

    [General] I do have the old style with the hose. Dave, do...

    I do have the old style with the hose. Dave, do you happen to have a picture of the plug for the distributor and coil? I am on an anniversary vacation, but will be working on the car this weekend. ...
  14. Replies
    49
    Views
    13,648

    [General] So it's not an engine warming issue. I wanted to...

    So it's not an engine warming issue. I wanted to move the car to another garage that had more room. I started it up, backed up, and drove the 300 feet to the end of my street. When I pushed in the...
  15. Replies
    49
    Views
    13,648

    [General] Previously, I had driven about an hour and a...

    Previously, I had driven about an hour and a half, stopped for a few hours, then drove back home and everything was fine. On Monday, I drove maybe 25 minutes, stopped for about an hour, then drove...
  16. Replies
    49
    Views
    13,648

    [General] Sorry, I should have said what I already...

    Sorry, I should have said what I already corrected from the last time it happened. Solid state rpm relay. Cleaned all grounds and ran a new ground for inertia switch. Cleaned rear ballast resistor...
  17. Replies
    49
    Views
    13,648

    [General] Engine Dies while Driving

    So I ran into this a few months ago and very appreciative for everyone's help. My car died on the road and after troubleshooting all electrical, I ended up replacing my fuel pump, primed the lines,...
  18. Replies
    56
    Views
    11,516

    [Engine] If there's a 50/50 chance, 90% of the time I will...

    If there's a 50/50 chance, 90% of the time I will choose wrong. Haha.

    Had the lines reversed, but it actually did not matter at that point...I heard the pump turning on to prime, but I wanted to...
  19. Replies
    56
    Views
    11,516

    [Engine] I just got my new pump and installed it. I put...

    I just got my new pump and installed it. I put fresh gas in the tank, turned the key and heard the pump turn on. However, the engine would not start. I tried pumping the gas a little while turning...
  20. Replies
    56
    Views
    11,516

    [Engine] Took out the fuel pump over the weekend and...

    Took out the fuel pump over the weekend and played around with it quite a bit. Its definitely dead. Ordered a new one and should be here by Friday. Will let everyone know how it goes.

    Thank you...
  21. Replies
    56
    Views
    11,516

    [Engine] Sorry its been a while. I was away for business....

    Sorry its been a while. I was away for business. Not much progress...I took off each adapter and took some corrosion off. Still only getting 8.3 V at the fuel pump. Is there something I can test?...
  22. Replies
    56
    Views
    11,516

    [Engine] That's in the engine compartment, right? Would...

    That's in the engine compartment, right? Would someone please provide me with a picture just so I know I'm checking the correct item?
  23. Replies
    56
    Views
    11,516

    [Engine] Did this and it read -1.42 V

    Did this and it read -1.42 V
  24. Replies
    56
    Views
    11,516

    [Engine] Is 12.14 Normal for the battery?

    Is 12.14 Normal for the battery?
  25. Replies
    56
    Views
    11,516

    [Engine] Any suggestions on a good one to replace it with?...

    Any suggestions on a good one to replace it with? I've seen the "Fuel Pump 909" search on ebay one for $50 and it looks fairly easy to replace. Or is it worth it to do the the DMCH one?
Results 1 to 25 of 164
Page 1 of 7 1 2 3 4