All, I have been working on the right hand side head, in that I have removed it again believing it to be cracked, once I removed it (completely) and removed the exhaust manifold it appears that the...
Type: Posts; User: northeast dmc
All, I have been working on the right hand side head, in that I have removed it again believing it to be cracked, once I removed it (completely) and removed the exhaust manifold it appears that the...
Ok thanks.
Hi, its been awhile since I have been on and or posted, which is a good thing on one hand. But unfortunately, the head gasket leak has gotten worse and now have a trace of anti freeze in the oil. So...
Well I was able to find the issue with the door locks, it was the passenger door front latch. Despite the door closing and latching, the front latch wasnt going far enough to allow the door locks to...
I am unfamiliar with the impact sensor and the ECU. I have not installed the ECU and not sure where to look. So if you could elaborate more that would be great. Would the impact sensor be the inertia...
Hello, its been a while since I have been on. I have started back in on the car trying to get to some of the stuff I pushed down the road. First task I have started on is the door locks.. I pulled...
Thank you for the help.
Hi, well mystery some what solved, finally traced the wires for the diode and it was removed and hard wired in. Now the question is this something I can get at any parts store, and if so what is the...
I will have to check this out. An update, I faithfully check the antifreeze and the oil before I go anywhere, call me paranoid, but I went out this morning to meet up for breakfast with a couple guys...
Well I had an occasion to take the car out this afternoon. And as has been the case the temp got up to around 220. On the way home I drove without the A/C to see what the temp would do. When I got...
I did turn the A/C off just before I got home so I could make sure that wasnt in the mix. I will check the relay, I have a lot of different stuff from different sources. The temperature used to stay...
Hello again, I have been enjoying driving the car, my question/concern is after driving for a while the temperature creeps to around 220 or just over. It will stay in that area, depending on driving...
Ok thank you.
I had an issue with my lower ball joint, not being aware of the issue with the nut backing off. I was fortunate enough that a guy had a spare one, and I ordered two in the meantime before being made...
Yes the climate control does in fact turn hard, I dont hear any hissing as such but then I do where hearing aids. I do however hear a difference in how the car runs when I shut the hvac completely...
Thanks to the responses and the support, at least I am not alone. Next attempt will be with decaf. And it sounds like I need to get the outer seals on first, the one suggested sequence talked about...
Ok, before I remove the door in an unprofessional way and cause myself alot of added grief. I have followed a door alignment process in which (short version) you remove the strut loosen the hinges...
Thank you, I am strongly suspecting vacuum as it happened almost at the exact time I worked on getting the A/C in running order. Has there been any issue with the climate control unit in the dash...
Hello again, well I have been out driving around and getting to a couple of get togethers with some of the other delorean guys in the area. Great time. Any way the car starts and runs good, drives...
Well, I have been putting the miles on and generally speaking seems to be good. I need to lube the connector rod for the throttle, which will be today. Any way my question is regarding seat covers,...
Update, since posting the messsage, I took the relay apart looking for anything obvious, nothing to see, put it back together, and for ha ha's plugged it back in connected the ground and the wipers...
and on to the next item. When I got the car, my brother had wires and a remote switch to operate the wipers. At one point I took the control arm for the wipers out thinking it to be bad. I tested the...
Thanks again, the hot water valve is a new twist to me, but do recall hooking it up when I put the motor in and hooked up the hoses. Wondered what that was for. I did put in anew fan motor that was...
Not positive I follow the hot water control valve. I am guessing you mean the temperature control knob on the dash?
Thanks, do you have a picture showing the plastic piece, I assume you used it to keep the seal just below the outer surface or even with it??( I hate to assume, always gets me in trouble, and at...