Search:

Type: Posts; User: DMC-81

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. [Electrical] PMd. Its nice to have a spare. Great work. I...

    PMd. Its nice to have a spare. Great work. I laughed at the BTTF reference. :)
  2. Replies
    247
    Views
    66,156

    Nice! I see it is a Turbo as well. :)

    Nice! I see it is a Turbo as well. :)
  3. [Frame & Body] Hi Jonathan. I think the yellow zinc plated one...

    Hi Jonathan. I think the yellow zinc plated one is original or an older replacement. I have the same plated ones on my car and they have not been replaced. Here’s a picture:...
  4. Replies
    25
    Views
    8,075

    I have DMCH seat covers. Love them. I paid the...

    I have DMCH seat covers. Love them. I paid the extra little bit for the original wrinkle design because originality is important to me, and I figure that extra material will be beneficial to allow...
  5. Replies
    23
    Views
    758

    [General] Looking good! Also congrats on your wife's...

    Looking good! Also congrats on your wife's graduation.

    There is a technique where you disconnect and slide the inner column back (retract) and then move the column slightly to the side just enough...
  6. Your response is as classy as the video. ...

    Your response is as classy as the video.



    Very wrong, and I'm afraid you missed the larger point which was prudent security. But, I'm sure you can figure it out.
  7. Replies
    23
    Views
    758

    [General] You're welcome. Yes, they should be. They were...

    You're welcome. Yes, they should be. They were the same in the full kit that I got from DMCH. The new ones should look much like the ones in the PDF and the old ones. You can call Mike at DMCMW if...
  8. Thanks for the very kind words Jonathan! :) ...

    Thanks for the very kind words Jonathan! :)

    One thing I always enjoy about shows is talking to the spectators. One family that stood out in particular from Sunday's show was a couple with their...
  9. Replies
    23
    Views
    758

    [General] Hi Austin, Yes, I have two pieces of advice: ...

    Hi Austin,

    Yes, I have two pieces of advice:

    1) Make sure you get the bushing installation procedure from Robert. If not, send me a PM with your email address and I'll send it to you. It makes...
  10. Thanks Colin! I was honored to even be among them.

    Thanks Colin! I was honored to even be among them.
  11. Replies
    28
    Views
    662

    [General] My advice is to shop the rates for the same...

    My advice is to shop the rates for the same coverage that you want/need. Then, after a year, shop again at renewal. There's no reward for loyalty to your insurance company. In fact, I've found it's...
  12. RITZ-CARLTON ORLANDO FESTIVALS OF SPEED, December 2nd, 2018

    Ever since I first attended the Ritz-Carlton Orlando Festivals of Speed a little more than a decade ago, I wanted to show a car at this prestigious event located in a picturesque setting on the...
  13. Replies
    5
    Views
    273

    I'll be there as well. Looking forward to it.

    I'll be there as well. Looking forward to it.
  14. Replies
    23
    Views
    758

    [General] Congrats! It looks like a solid car and you're...

    Congrats! It looks like a solid car and you're off to a good start on what it needs.

    Cheers,
  15. Replies
    9
    Views
    768

    I agree. When I reconditioned my manifolds and...

    I agree. When I reconditioned my manifolds and put new gaskets on, it made such a difference in the car. Not only sound but the performance as well. I also used high temperature RTV gasket maker as...
  16. Replies
    10
    Views
    486

    [General] That looks pretty good. Is it the same one that...

    That looks pretty good. Is it the same one that Boxbot linked to above, and are you saying that it works with the stock lighter receptical?( I.e. It doesn't tend to want to fall out)

    Thanks.
  17. [Fuel] Is the leak point the area around the 12 mm...

    Is the leak point the area around the 12 mm hollow bolt in the banjo fitting?

    I had some experience with this. Mine had a thicker section at the top:...
  18. Replies
    19
    Views
    1,052

    This looks like a very good car, but, if it is...

    This looks like a very good car, but, if it is truly a 500 mile car, it was stored improperly at some point due to the rusty fasteners & hardware on the exterior as mentioned. In addition to what was...
  19. Replies
    11
    Views
    312

    [Engine] Good advice offered so far. I'll add the...

    Good advice offered so far. I'll add the suggestion to make sure the cruise control system is completely unplugged/disconnected while you are troubleshooting to eliminate that as a cause.
  20. Replies
    14
    Views
    594

    [General] Thanks very much. :) Yes, besides the fascias,...

    Thanks very much. :)

    Yes, besides the fascias, I had the the front lower air dam and louvers professionally painted in SEM Trim Black with a satin clearcoat. They turned out well. I think the bill...
  21. Replies
    14
    Views
    594

    [General] If it helps with the comparison, here is a...

    If it helps with the comparison, here is a picture of my car in low versus bright light:

    http://dmctalk.org/attachment.php?attachmentid=47390&d=1479172701
    ...
  22. Replies
    14
    Views
    594

    [General] I really like your wheels. Of course, I'm a bit...

    I really like your wheels. Of course, I'm a bit biased as I have an early car as well.

    Since you have one of 1381 cars with dark gray wheels (VIN 1883 - 502) minus the cars that didn't survive, I...
  23. Replies
    11
    Views
    1,256

    Hi Mark. Sorry I missed you. Because the show...

    Hi Mark. Sorry I missed you. Because the show goes on for 4 days, it is more of a display-only format. I was there on Sunday afternoon with one of my daughters.

    Hopefully you enjoyed the show.
    ...
  24. Replies
    4
    Views
    227

    [Suspension] Been there, done that. DMC part number 105257....

    Been there, done that.

    DMC part number 105257. $6 Does both the ball joint and the tie rod end. I replaced all 4 on my car.

    http://store.delorean.com/p-7315-boot-lwr-ball-jointtie-rod-end.aspx...
  25. Replies
    15
    Views
    478

    [Transmission 5-Speed] Lee, can you pinpoint the area where it is...

    Lee, can you pinpoint the area where it is dripping from? There is a guide tube that seats up against the lip seal inside the gearbox. The other end of guide tube has a hole in it pointed down, about...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4