Search:

Type: Posts; User: jamesrguk

Page 1 of 8 1 2 3 4

Search: Search took 0.06 seconds.

  1. Replies
    32
    Views
    6,082

    Not sure how thick J.H's stripes are, most of the...

    Not sure how thick J.H's stripes are, most of the reproduction stripes are thin vinyl and as such can simply be wrapped around the end using a blunt plastic spatula of some kind, thicker stripes may...
  2. Replies
    2
    Views
    379

    [For Sale] Ron, I completely agree, I had intended for the...

    Ron, I completely agree, I had intended for the single photo of the black frame to be in position 1 but before I realised they were in the wrong order someone had bid, at which point you canít change...
  3. Replies
    2
    Views
    379

    [For Sale] DeLorean Lisence Bezel Photo Frames

    I made these some time ago and have had them on display for the past 6 months at home with family photos in, they get lots of comments and are quite striking.

    With Christmas upon us I'm looking to...
  4. [Electrical] I could send them out on contact paper, I have...

    I could send them out on contact paper, I have successfully used masking tape in place of contact paper, you could give that a try. I sell loads of these and I have to sit weeding the waste material...
  5. Replies
    77
    Views
    10,838

    [General] http://www.ebay.co.uk/itm/DeLorean-Headlight-Hazar...

    http://www.ebay.co.uk/itm/DeLorean-Headlight-Hazard-Switch-Sticker-Decal-Kit-new-for-2015-/181717082348?hash=item2a4f2ea0ec:g:5SwAAOSwymxVLXNV

    I've sold bucket loads of these over the past few...
  6. Replies
    33
    Views
    3,432

    [Frame & Body] I know Chris Nicholson never finished this LFF,...

    I know Chris Nicholson never finished this LFF, probably too busy, but it shows what can be done.

    http://www.pjgrady.co.uk/new-left-front-fender

    At the end of the day with enough skill, time...
  7. Replies
    33
    Views
    3,432

    [Frame & Body] Moving from carbon panels, what about the tub

    I agree that there would be little weight saving with carbon fibre panels, the stainless is relatively thin after all.

    However I always wondered what weight saving could be made with a carbon...
  8. Replies
    47
    Views
    7,659

    [Engine] I didn't have that screen on my stock DMC engine...

    I didn't have that screen on my stock DMC engine when I bought the car in '99, I did actually overheat that engine after about 9 years of ownership due to a split in the coolant jacket. But also I...
  9. Replies
    4
    Views
    1,308

    [General] I use my car daily and I too have recently had a...

    I use my car daily and I too have recently had a couple of hoses which have started dripping no doubt due to the drop intemperature, the hoses are all less than 6 months old so a quick re-torque with...
  10. Replies
    10
    Views
    1,500

    [General] 5470 I'm 5462 I think that's the closest vin I've...

    5470 I'm 5462 I think that's the closest vin I've seen to mine.

    J

    Sent from my SM-G920F using Tapatalk
  11. [Suspension] I really don't understand why you would fit...

    I really don't understand why you would fit anything other that the DeLorean EuroTec ball joint which was researched and manufactured specifically for this application.

    Skimp on some parts by all...
  12. Replies
    2
    Views
    555

    [Frame & Body] Pretty sure they're the same product, hence same...

    Pretty sure they're the same product, hence same picture, exchange rate and shipping makes one more pricey than the other.

    Matt black vinyl with 3D style DMC logo, I have them on my car, other...
  13. Replies
    39
    Views
    7,281

    I dumped in the full Volvo b28e engine into my...

    I dumped in the full Volvo b28e engine into my car last year, due to my own one suffering block rot.

    It's a much nicer drive and I look forward to popping it on a dyno in the future but...
  14. [For Sale] I'm embarrassed to admit that I have one of these...

    I'm embarrassed to admit that I have one of these thrown on a heap of spare odds'n'sods in the corner of my garage.

    I had it installed for a few years then went back to stock, mainly because it...
  15. Replies
    1,698
    Views
    313,444

    The 'does it run' question...

    I've owned my D for some 15years now, I'm mid 30's so I still consider my self a young owner of such a car.

    My car used to be a weekend driver in summer only etc... But in the last few years it...
  16. Replies
    33
    Views
    7,366

    [General] I've always been a little sceptical of those fire...

    I've always been a little sceptical of those fire suppressor systems, probably without cause.

    Indeed I've seen one in action, all be it not in a car, but I would worry that whilst it may smother...
  17. Replies
    3
    Views
    910

    [Wanted] There must be some vendors who have engines with...

    There must be some vendors who have engines with block rot sitting around, it doesn't usually effect the lower end.

    Might be worth an email to Ed Uding or on of the US vendors.

    J
  18. [General] I notice that a couple of manufacturers such as...

    I notice that a couple of manufacturers such as Bridgestone and General Grappers are offered in 255 60 R15, would a 255 fit on the DMC rim, it's only 20mm wider, would that be an issue?

    [Edit]...
  19. Replies
    1,698
    Views
    313,444

    I love it when people ask how much I paid for my...

    I love it when people ask how much I paid for my car as I say £9'500, then I get the pleasure of saying I wouldn't sell it for less than £25'000 (that seems the going price for a reasonable car in...
  20. Also there were two different wheel castings as...

    Also there were two different wheel castings as well as the colour choice of silver/grey.

    I doubt many people notice.

    41260

    41261

    J
  21. Replies
    16
    Views
    4,858

    I've just installed everything in your picture...

    I've just installed everything in your picture and more, obviously you need to get the car tracked after installation as the firmer bushes and LCA brackets will likely put the alignment out.

    When...
  22. Replies
    32
    Views
    6,082

    I think you're referring to those vinyl stickers...

    I think you're referring to those vinyl stickers which stick to very flat surfaces but are not sticky to the touch, the kind of thing that windscreen tax disk holders and car club 'stickers' are made...
  23. Replies
    32
    Views
    6,082

    No idea why, but whenever I upload photos to the...

    No idea why, but whenever I upload photos to the forum via iPad they flip upside down but here goes.

    Excuse the dirt, this car is pretty much my daily driver.... Here's the logo, it's silver vinyl...
  24. Replies
    32
    Views
    6,082

    I added a wide stripe to my car about 5years ago...

    I added a wide stripe to my car about 5years ago and love it, I even find when it's parked next to a non-striped D the one without the stripe looks naked.

    Mine is just Matt back vinyl but with the...
  25. Replies
    29
    Views
    5,854

    [General] This baby represents my first dabble into arc...

    This baby represents my first dabble into arc welding and has removed more DeLorean steering wheels than I care to remember.

    40739

    Despite being very primitive with my best 'pigeon poo'...
Results 1 to 25 of 195
Page 1 of 8 1 2 3 4