FRAMING JOHN DELOREAN - ON VOD www.framingjohndeloreanfilm.com

Search:

Type: Posts; User: Ratrace427

Page 1 of 5 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    11
    Views
    2,807

    if its voltage drop to the pump then that would...

    if its voltage drop to the pump then that would be from the cooling fans pulling power. what about unplugging the fans to test if the issue goes away. not saying the fans are bad but that would...
  2. meh.. sounds like it has some miles on it but...

    meh.. sounds like it has some miles on it but that electro magnet is strong. that will note cause it from pulling up to the pulley.

    Sent from my SM-G950U using Tapatalk
  3. is that the correct coil for her replacement...

    is that the correct coil for her replacement compressor? oh wait..never mind.

    Sent from my SM-G950U using Tapatalk
  4. that's awesome! nothing better than when it fixes...

    that's awesome! nothing better than when it fixes itself, but bad coils like to do that. If it stops working again that re-confirms the coil. I had one work one day and then stop the next. that...
  5. its just a bad clutch coil. its just a electro...

    its just a bad clutch coil. its just a electro magnet that grounds through the mounting bolts for the compressor and gets its power through that single wire. you have given it everything needed to...
  6. Replies
    49
    Views
    28,819

    [Heat & A/C] i disagree with replacing the evaporator. That...

    i disagree with replacing the evaporator. That took me hours....HOURS to change, but i had a leak. I would however check for a leak with a sniffer before thinking its toast. With a evaporator leak...
  7. Replies
    49
    Views
    28,819

    [Heat & A/C] You are just fighting corrosion and "O" ring...

    You are just fighting corrosion and "O" ring stickage. That hose just slides in there with the plastic orfice tube first. Did you try twisting the hose with a pair of channel locks at the strong...
  8. [General] I prefer the double outlet versions. also you...

    I prefer the double outlet versions. also you need to get a 2.5 amp output. some of the cheaper ones are low amp and won't fast charge your hardware.

    Sent from my SM-G950U using Tapatalk
  9. [Frame & Body] I found that the easiest way is to rinse the...

    I found that the easiest way is to rinse the whole car off with a water hose, then use four towels to dry it off in the direction of the grain. No soap just water. Use the sun to watch for streaks....
  10. Replies
    5
    Views
    1,608

    [Heat & A/C] there must be something inside the squirrel cage...

    there must be something inside the squirrel cage fan. just drop it down and clean it out. also put some spray lube around the bearing ends. pop the rubber vent tube out to lube it up

    Sent from...
  11. [General] you personally cant sell without having regrets....

    you personally cant sell without having regrets. if you were ready to sell you wouldnt be thinking so hard about it. When i sold mine i didnt think about it for very long, because I knew it was time....
  12. [General] I had mine for ten years. Seems like around the...

    I had mine for ten years. Seems like around the five year mark my driving time was cut way back. Then I started driving it again. Five years is that weird spot. If you sell it, buy another cool car...
  13. [Electrical] I wonder if someone snipped that ground off and...

    I wonder if someone snipped that ground off and ran it to another ground source. Previous electrical problem trouble shooting.Probably the ground for the radio. Where is the radio grounded now?
    ...
  14. Replies
    7
    Views
    2,578

    [Electrical] Most likely stuck. The mechanism will rust inside...

    Most likely stuck. The mechanism will rust inside the tube. Factory ones are really noisy anyways. Like really noisy

    Sent from my SM-G920R4 using Tapatalk
  15. Replies
    7
    Views
    2,578

    [Electrical] Hook each motor direct to a battery. Make a...

    Hook each motor direct to a battery. Make a jumper and start with the passenger side. It's close to the battery. Doesn't matter the polarity. Polarity changes the direction of movement

    Sent from...
  16. Replies
    10
    Views
    3,094

    [Frame & Body] Does it run up to the square port on the...

    Does it run up to the square port on the firewall?

    Sent from my SM-G920R4 using Tapatalk
  17. Replies
    10
    Views
    3,094

    [Frame & Body] Rh apost? Looks like the crank position sensor....

    Rh apost? Looks like the crank position sensor. What's left of it anyways. Only used during diagnosis and tuning

    Sent from my SM-G920R4 using Tapatalk
  18. [General] I really like purple clean or super clean. It's...

    I really like purple clean or super clean. It's in a purple bottle at Walmart. It will damage single stage paint if it's not diluted. Great stuff. It really breaks oil down. I usually do a fifty...
  19. [General] You could try disconnecting the Speedo cable from...

    You could try disconnecting the Speedo cable from the lamda box

    Sent from my SM-G920R4 using Tapatalk
  20. [Fuel] Oh yeah..i am very familiar with that issue. I...

    Oh yeah..i am very familiar with that issue. I changed all the rubber pieces around the fuel pump on my car and I still couldn't fill the tank up. Pull that top rubber piece off by removing the big...
  21. Replies
    23
    Views
    8,420

    [Engine] Running rich or lean will not produce white...

    Running rich or lean will not produce white smoke. Crazy old varnish for gas might..

    Sent from my SM-G920R4 using Tapatalk
  22. Replies
    23
    Views
    8,420

    [Engine] How old is the gas? Sent from my SM-G920R4...

    How old is the gas?

    Sent from my SM-G920R4 using Tapatalk
  23. Replies
    23
    Views
    8,420

    [Engine] Bad head gasket..idk. Is the oil milky? How about...

    Bad head gasket..idk. Is the oil milky? How about light brown fluffy oil around filler cap? I don't think a bad head gasket would create hard starting like you are describing. I guess depending on...
  24. Replies
    6
    Views
    2,543

    [Suspension] Tie rod ends thread onto the rack. You should be...

    Tie rod ends thread onto the rack. You should be able to get a new end with the same thread. You can see in the photo the flats you hold with a open end wrench and the teeth marks from a pipe wrench....
  25. Replies
    8
    Views
    1,975

    [General] Is it the same size as the bottom of the air...

    Is it the same size as the bottom of the air filter box?

    Sent from my SM-G920R4 using Tapatalk
Results 1 to 25 of 108
Page 1 of 5 1 2 3 4