Lovely stuff, looks really well
Type: Posts; User: cis6409
Lovely stuff, looks really well
Great idea for the cups in the intake holes! , catches any debris easily and stops anything from passing inside:o
Thanks Ethan, I'll go for 3/8" then
Cheers
Hi,
Does anyone know what thickness (outside diameter) of the frame hardline that goes from engine to the brake servo part number #100416 is?
Is it imperial or metric size?
I need to make a new...
Cool pics!
Excellent to hear! , thanks for the update and explanation
Yes David is correct spray pattern is very important. I didn't describe it very well . They should all spray in a nice fine cone shape atomised spray.
Jumper the rpm relay by connecting the purple...
plus one on the injectors to as david mentioned. An injector flow test might be helpful here. I had injectors that were fine at idle flow test but turn crap when sensor flap was pressed a third of...
Yes agreed ,
If the dwell numbers are high on the scale you need to lean the idle mixture, if the dwell readings are low you need to richen the idle mixture.
the dwell number your reading is...
No, the tank doesn't sit at an angle in the chassis I believe , but the combination of the baffle design/size, and location towards the back of the tank means it can always keep a minimum amount...
Mine has oem set up and runs right down to the low warning Light no problem.
Looking at the integrated pump sender pics set up I can't see how it can suck fuel from the baffle location at the...
Great work, Very interesting results, Thanks for posting them.
Very enlightening
Shane
Those washers do seem larger than normal. The one on the right is the correct size..they should be m8 size for those connections.
Yes the larger line from the drivers side is the feed from the...
Don't think that's right..
The green double wire (with single spade connector) goes to that lambda thermal sensor.
Also the other connector for the idle speed speed thermistor should be the...
+1 for me to.. - (IF all the other things check out like both fans working ETC) . The A/C making it go hotter seems to be more of a symptom not the cause. It's exposing a weakness in the cooling...
The 3 connectors,
The ring terminal with the red heat shrink looks like the ground for the fuel ecu.. Its bolted to the the back right of the intake manifold usually beside cylinder 1.
The small...
Most excellent thread, very interesting!
I will be refurbishing my gear linkage soon and it will come in very handy for it , great timing :)
Shane
Just read your thread post #27 there Dana, fantastic write up , that is a huge help.
Have a good idea where the molex side of the connector is located now and how to feed it through.
Virtually...
Thanks guys for the replies.
excellent stuff will check out that thread and have a closer look at the plastic connector.
Thanks a mill,
Shane
Hi guys
Just wondering is it a big job to replace these 2 looms for the air con dryer.
I have a broken wire on one of the Connectors and I can't see a way of getting into the terminals without...
I didn't know you were delorean less either! (not on Facebook myself to)
It's a huge decision to move like that but congrats and best of luck with it, hopefully you ll be an owner again soon....
Thanks for that guys
I didn't know some come with the grommet pre-installed. I'll check it out.
You learn something new every day with these cars!
Thanks
Does anyone have any tips for installing the rubber grommet over the lower speedo cable. I have bought a new lower cable and grommet.
With some heat I can get the grommet to slip over the end part, ...
O I see now, excellent thanks!
Shane
I've got the plate refitted
Great to finally have it in the correct place and not hanging down..
One other question the flasher relay is supposed to be attached to that aswell but instead of the...