Well, I was told they don't have the proper tools to do the alignment. Shields are off as well...Again this was a basic tire repair shop that looked at the Delorean as if it were a UFO. The front toe...
Type: Posts; User: dmcburn75
Well, I was told they don't have the proper tools to do the alignment. Shields are off as well...Again this was a basic tire repair shop that looked at the Delorean as if it were a UFO. The front toe...
After getting my alignment checked I was told my right rear toe is at -.07 when the acceptable range is between +.20 to +.28 degrees.
I have 5 shims on the RR TAB so my question is would removing...
Well, I finally went for the spax shocks. They look good and are all black which I think is more fitting then the original yellow.
I just wanted to get a consensus as to the settings you all are...
Andy, it is on the driver side of the console coming from the AC panel running towards the back of the engine. It's either going to to heater valve or the pontoon vacuum canister. It is a very slim...
My advice is to study the removal of the intake manifold which I believe there is a write up for... Bag and tag everything. I can usually get the engine out in about 3 hrs using air tools. You will...
After removing my center console I noticed one of the vacuum lines on the driver side that runs to the rear is broken. It is the thinner plastic type line; I've been having problems with my AC...
Ok so here is the problem. I'll turn the AC and fans on and everything will be running ok albeit not very cold. After maybe 5-10min the fans will just shut off for 1-5min even though the switch is...
Prior to getting my freon topped off, the compressor was cycling on and off every 3 seconds. Now, while at idle it seems to run for a long time. Once I goose the throttle to 3000rpm or so it shuts...