Looks like the koenigsegg gemera
Sent from my SM-N950F using Tapatalk
Type: Posts; User: Acmetowers
Looks like the koenigsegg gemera
Sent from my SM-N950F using Tapatalk
Perhaps they were taking about this old thing http://www.deloreanaerospace.com/
Sent from my SM-N950F using Tapatalk
Good point forgot about those!
Sent from my SM-N950F using Tapatalk
It'll be a long job but if you remove the t panel you'll be able to short out the door locks or window by the door harness.
Sent from my SM-N950F using Tapatalk
Chances of a fire after an accident is very small (unless you believe Hollywood) and as you know inertia switches can be set off due to pot holes. I feel that if you modify the car so that systems...
I'd be a bit worried about switching off the battery supply if the inertia switch triggers. If your in that situation at night you'll be at the mercy of passing traffic to see you as all your...
I have the exact same issue, idles at 2k when it's warm. If I blip the throttle it drops back to 800. Found out the throttle linkage was out but now wondering if it's the air bypass motors sticking...
Also I wouldn't trust the gauge if it's come from a red box. I've seen those out by half a bar as they're not calibrated.
Sent from my SM-N950F using Tapatalk
One issue with a digital display is the visual swing, it's a lot easier to see with an analog gauge. I've tried a fluke 123 scope to measure the signal but it was easier with a 1980s dwell meter.
...
Regarding what kit to use, I made one based around a 6 bar calibrated gauge with bits from the Chinese kit and some banjo fittings from some old fuel lines. But to make your own all you need is a...
I've just had to fix this issue with idle hunting and bad emissions. I'd say before you start adjusting the CO check your timing and fuel pressures. My vehicle failed its emissions >9.99% CO HC...
I've just finished getting mine back to stainless. I used peelaway 7, takes longer as you just paste on the stripper and leave it a day or so to do its work, but after this the vast majority of...
I just used some fibreglass sheet and resin. With just a few layers it was strong enough and when sanded down was flush to the backing board.
Sent from my SM-N950F using Tapatalk
Lucky there wasn't anyone in the passenger seat. One thing I would say in that situation is that I've always been told to turn off the ac to reduce load on the engine and put the cabin heater to max...