You are not running Kjet though either.
Type: Posts; User: Josh
You are not running Kjet though either.
with any of the limited rear engined transaxle options we have there are none or minimal options for different final drives. It is always a compromise. Unless you want to start paying 10-15 K for a...
Everytime you post it takes a week off my life.
That sounds about right. THat is the G96/00 /01's predecessor. Much more expensive to obtain as well but near the same capabilities. Still no confirmation of max rpm, perhaps the porsche forums will...
All the GM pumps should be at least 100psi if they are manufactured to oem specs. but if its not published it is impossible to know.
That is a completely different pump Hervey was selling. it is from a 2003-2007 flexfuel gm truck. The pump is larger capacity due to flexfuel. Its not a great fit for the car. Furthermore he ...
You are mostly right. The 2005-2006 LS4 was a bit of an experimental engine along with the E40 ecu. FOr example it had a gen3 24x crank trigger, with DoD (bosses in the block) and gen4 rods/pistons....
I doubt the 20B car had a G96, I think it had an older porsche transmission. 915 perhaps. I would not assume that it was a good fit for the motor.
I am working with an owner in the UK to adapt a Honda K-series to the stock transaxle.
Other adapters I have designed or helped with designing:
GM Ecotec to stock transaxle
Honda J series to...
The LS2 is a gen3 and the 4 is a gen3/4. The 7 is also a bit of a hybrid.
None of the ls engines other than the 4 got displacement on demand. Also it has been observed in the community that it...
Its interesting that they put them on a ruler, but dont measure the bolt properly (underhead length) or in the correct unit. I suppose it helps sell more bolts.
It is very common to remove the rear of the frame as you describe, Many PRV cars have this modification. You do not need to angle the engine so much or lift it as high when removing.
It is required...
I do require a few holes to be drilled for my swaps but it is very minimal, 10 mins with a drill, no welding and no structural impact.
If i wanted to I could revert everything back to stock with no...
Its actually terrifying with our suspension setup.
65936
From "Fastest Delorean in the World" on a 12 second pass.
If you had stock suspension or poorly setup coil overs at this power level it is entirely possible to lift the front tires off the ground.
I would also like to confirm that they are 8" c-c
There is a restoration section of the forum, I dont feel engine swaps are mis-represented.
Ive went through this several times with the EJ, it is simply far to wide to fit in the frame. The valve...
If you take the car back to your local DMC dealer it was originally sold at in 1981 I'm sure they will push this warranty issue right through the system real quick.
This is awesome. That car is putting down some serious power, especially considering its on a mustang dyno.
I need to hurry up, put my car back together and see if I can keep up!!
Great job Nick...
drive the car more, and for longer trips.
Thats what Ill be doing this summer likely. The guy that does my fiberglass work is busy is a farmer so winter is his downtime.
There are no alternatives for our car that work better than speed box and/or are cheaper.
I remember in highschool shop class we had no batteries. So to get a car going we would start it with a battery charger to the battery leads, then disconnect it after it was running so we could drive...
I have two GPS antennas in my car, one for my radio and one for my speedbox. I just stick them to the top of the radio bracket (above the vents). Then install the console as usual. They work fine and...