Search:

Here is a link to the AT&T commercial.

https://www.youtube.com/watch?v=fmD6ntwtz0s

Have my console out of the car right now. Measuring in the same location as your ruler I get 1.15 inches or 29 mm.

Thanks everyone for the advice. I may see if I can source some trim locally as I would like to finish this up this weekend. If not I will contact one of the DeLorean vendors.

Hoping that someone can help me find the right part for my frame. I am looking for the trim that goes around the larger holes in the frame but can't seem to find a part number. Here is a picture of...

Thank you all for the help. Vent hole looked OK but cleaned it out just in case. My plan is to clean up the oil around the bolt and keep an eye on it. If the leak is very small I may let it go for...

The leak is relatively small right now.

How do I tell if the transmission vent is plugged?

Took my transmission out about 2 years ago and drained the oil. It wasn't leaking then...

A week ago I filled it back up with oil and now it is leaking from this bolt. Why this leaks doesn't make...

Thanks, I may give that a try.

The folded staples aren't holding much so they will probably come out.



Any suggestions about fasteners? I searched for roof box fasteners but did find much.

While I have the engine out of the car I would like to clean up the engine compartment and repaint. All along the fiberglass seam there are these staples, some are obviously bent like the ones in the...

Awesome mod. I've been planning on replacing the radio but now I may have to think again.

My boards are out right now so I took a quick look and the 2 brake lights on each board are in parallel. This makes sense because if one bulb burns out the other bulb will still work.

Just testing it makes sense but unfortunately I don't have a hydraulic hand pump and the new clutch master is not installed in the car yet. When I measured the flywheel surface to the motor surface...

For the past couple years I've been slowly rebuilding my Delorean and in the process I am converting it to electric. Yes, another electric Delorean. I've got lots of pictures and some day may create...

The screen is looking good and it looks like it is a nice fit in the binnacle. What type of computer are you using to run "Processing" and drive the graphics?

Very nice. Looking forward to seeing what EVWest does with the car. From the pictures and images I have seen it looks like they do some excellent work with electric vehicles.

Not a flux capacitor, but for Android there is an app by Utz software that looks OK on my phone. I think it is called Time Machine Clock. There are others as well but I haven't tried them.

With that many LEDs your rear bumper could be a TV screen. You could do some cool animations too like making it a scrolling marquee.

This sounds like a fun project but there are a couple of things...

Mine just came today - looks very nice.

Is it possible to replace the boot on the parking brake cable? My cable is in good shape but while I have the car apart I would like to replace all of the original rubber. I don't see any way of...

When I used the term "minor" I may have been understating the issue. Here is a picture of the flywheel. You can see the grooves and the rust marks where the original clutch sat for many years.
30950

The clutch is being replaced. Is there typically a large variance in the step size? This is an original flywheel and it has never been resurfaced.

I am taking my flywheel in for resurfacing due to some minor grooves and some minor rust from sitting too long. However when I measure the step size I am getting closer to 22 thousands for the step. ...

Thanks for the info.

David

Currently rebuilding my steering rack and need to replace the oil. I believe that the original oil was 90W which I cannot find locally. For my transmission I am planning on using red line MT-90...